Universal Electronics ATLAS OCAP manual Deleting a Single Learning Key, TV, or CBL

Atlas OCAP M1056L.fm Page 16 Friday, December 22, 2006 6:10 PM

the key on the original remote until the Atlas OCAP 5-Device Remote Control with Learning’s LED blinks twice.

NOTE: If the LED displays one long blink, a learning error has occurred. Try repeating this step

again until a successful capture occurs. If the function is still not captured, press and hold SETUP to exit programming and review the

“Learning Precautions” on the previous page. If needed, also see “Troubleshooting” on page 25. After review, start programming again at step 1.

6.Repeat steps 2 through 5 for another mode

and/or key or press and hold SETUP to exit programming.

Deleting a Single Learning Key

This process returns the key to its original programming for the mode you select. You can also delete learned programming by teaching a different function to the key (see “Programming a Learned Key” on page 15)

NOTE: If more than 15 seconds pass between key presses, the remote exits programming.

1.Press and hold SETUP until the last-selected

mode key blinks twice, then press 9 7 6.

2.Press a mode key once (i.e., VCR, DVD, AUD,

TV, or CBL).

3.Press the key containing the learned function to be deleted twice. The remote will blink twice.

4.Repeat steps 2 through 3 for another key or

press and hold SETUP to exit programming.

www.urcsupport.com/atlasocap

16