Universal Electronics MILLENNIUMTM 3 manual Programming VCR Control, Setup Codes for VCRs

Page 12

Millennium 3 Mnl M3090 8/16/99 9:26 AM Page 12

PROGRAMMING VCR CONTROL

NOTE: If you own a TV/VCR combination, skip this section and perform “Programming TV/VCR Combo Control” on page 16.

Locate the brand name of your VCR in the Setup Codes For VCRs section below, and write it in the following space.

VCR Brand: __________________________________

The brands are listed in alphabetical order with the most popular codes listed first.You will use one of these codes to program the Millennium 3 to operate your VCR:

1.Turn on your VCR and insert a video cassette.

2. On the Millennium 3, press VCR once. Press and hold SETUP until the LED blinks twice, then release SETUP.

3.Enter the first four-digit code for your VCR. If you perform this procedure correctly, the LED will blink twice.

NOTE: If the LED did not blink twice after entering the code’s last digit, then repeat steps 2 through 3 and try entering the same code again.

4.Aim the Millennium 3 at your VCR and press VCR once. The VCR should turn off. If your VCR

remote control does not have a POWER key, press PLAY. If the VCR does not respond, repeat steps 2-3, trying each code listed for your brand until you find one that works. If the VCR still does not work , try searching for the code (see Searching For Your Code on page 22).

5.Write your VCR code in the boxes below for future reference.

NOTE: Remember, to use the Millennium 3 to operate your VCR, press VCR first.

Setup Codes for VCRs:

Admiral

0048

Adventura

0000

Aiko

0278

Aiwa

0037, 0000, 0307

Akai

0041, 0061, 0106

American High

0035

Asha

0240

12

Image 12
Contents Millennium Table of Contents Introduction Features and Functions Key Charts Key Charts Installing Batteries Setup Codes for TVs Programming TV ControlAOC CXC JBLJCB JVC KECKTV LXISSS TMKSetup Codes for VCRs Programming VCR ControlCCE HI-QKLH STS 0038 Programming TV/VCR Combo Control Setup Codes for TV/VCR Combos To unlock the Cable key To program the Cable keySetup Codes for Cable Converters To lock the Cable keyABC NSCSetup Codes for DBS Receivers HTSUsing the Shift KEY To Reset Channel Control To Cable ConverterTo Reset VCR Transport Keys for VCR Use To Activate TV’s Channel Control CapabilitiesSearching for Your Code Checking the Codes Enter 9 9 0. The LED will blink twiceTo program Option to remember channels To program Option for all On/OffTo clear the Option key Troubleshooting ProblemSolution Additional Information Millennium 3 Mnl M3090 8/16/99 926 AM