Programming TV Control, Aoc | Universal Electronics MILLENNIUMTM 3

Millennium 3 Mnl M3090 8/16/99 9:26 AM Page 8

PROGRAMMING TV CONTROL

NOTE: If you own a TV/VCR combination, skip this section and perform “Programming TV/VCR Combo Control” on page 16.

Locate the brand name of your TV in the Setup Codes For TVs section below, and write it in the following space.

TV Brand: __________________________________

The brands are listed in alphabetical order with the most popular codes listed first.You will use one of these codes to program the Millennium 3 to operate your TV:

1.Turn on the TV.

2. On the Millennium 3, press TV once. Press and hold SETUP until the LED blinks twice, then release SETUP.

3.Enter the first four-digit code for your TV. If you perform this procedure correctly, the LED will blink twice.

NOTE: If the LED did not blink twice after entering the code’s last digit, then repeat steps 2 through 3 and try entering the same code again.

4.Aim the Millennium 3 at your TV and press TV once. The TV should turn off. If it does not respond, repeat steps 2-3, trying each code for your brand until you find one that works. If it still does not work, try searching for the code (see Searching For Your Code on page 22).

5.Write your TV code in the boxes below for future reference.

NOTE: Remember, to use the Millennium 3 to operate your TV, press TV first.

Setup Codes for TVs:

A-Mark	0003
AOC	0030, 0019, 0003, 0052, 0185
Abex	0032
Admiral	0093
Adventura	0046
Aiko	0092
Akai	0030
Alaron	0179
Ambassador	0177
	8