Universal Electronics MILLENNIUMTM 3 manual Troubleshooting, Problem, Solution

Millennium 3 Mnl M3090 8/16/99 9:26 AM Page 26

TROUBLESHOOTING

PROBLEM:	LED does not blink or blinks twice when you
	press a key.
SOLUTION:	Replace the batteries with two (2) new AA
	alkaline batteries (see page 7).
PROBLEM:	LED blinks when you press a key, but home
	entertainment component does not respond.
SOLUTION: Make sure you are aiming the Millennium 3 at
	your home entertainment component and that
	you are within 15 feet of the component you are
	trying to control.
PROBLEM:	The Millennium 3 does not control home enter-
	tainment components or commands are not per-
	forming properly.
SOLUTION:	Try all listed codes for the component brand
	being set up. Make sure all components can be
	operated with an infrared remote control.
PROBLEM:	TV/VCR combo does not respond properly.
SOLUTION:	Use the VCR codes for your brand. Some combo
	units may require both a TV code and a VCR
	code for full operation (see page 16).
PROBLEM:	CH+ , CH – , and LAST do not work for your
	RCA TV.
SOLUTION:	Due to RCA design (1983-1987), only the original
	remote control will operate these functions.
PROBLEM:	Changing channels does not work properly.
SOLUTION:	If original remote control required pressing
	ENTER to change channels, press ENTER on the
	Millennium 3 after entering a channel number.
PROBLEM:	Tried “Search Method”and still could not find a
	working code.
SOLUTION:	Try the “Search Method”again after clearing out
	the device key as follows: Press and hold ENTER
	until red light blinks twice, then release. Next
	enter 9 - 9 - 2. Then press and release the device
	key to be cleared twice.
PROBLEM:	Remote control does not turn on Sony or Sharp
	TV/VCR Combo.
SOLUTION:	For power on, these products require program-
	ming TV codes on the Millennium 3. For Sony,

use TV code 0000 and VCR code 0032. For Sharp, use TV code 0093 and VCR code 0048.

26