Precor P/N 300753-201 manual Attach the upright support to the base frame

Assembling the EFX 21

3.Attach the left upright support to the base frame using four buttonhead screws, four split washers, and four ⁵₁₆-inch washers. Partially tighten the fasteners.

Figure 4: Attach the upright support to the base frame

4.Repeat steps 2 through 4 to attach the right upright support.

5.Using a right-angle ³₁₆" hex wrench, remove the four ¹₄" x ³₄" buttonhead screws securing the central plastic base cover.

6.Remove the tape at the top of the left upright support.

7.Feed one of the cables you want to install down through the upright support, then along the inside of the foot support and back through the central frame member. The following illustration shows the general path of the cable.

Figure 5: EFX cable path