Precor P/N 300753-201 manual Important Safety Instructions

Page 7

Important Safety Instructions

5

Proper Location for Equipment

For all equipment other than treadmills: Locate at least 40 inches (1 meter) away from walls or furniture on either side of the equipment, and 40 inches (1 meter) away from objects behind the equipment.

For treadmills: Locate at least 40 inches (1 meter) away from walls or furniture on either side of the treadmill, and at least 80 inches (2 meters) away from objects behind the treadmill.

Important: These location standards should also be used when positioning equipment away from sources of heat, such as radiators, heat registers, and stoves. Avoid temperature extremes.

Keep equipment away from water and moisture. Avoid dropping anything on or spilling anything inside the equipment to prevent electric shock or damage to the electronics.

When using the treadmill, always attach the safety clip to your clothing before beginning your workout. Failure to use the safety clip may pose a greater risk of injury in the event of a fall.

Do not operate electrically powered equipment in damp or wet locations.

Never operate this equipment if it has a damaged cord or plug, if it is not working properly, or if it has been dropped, damaged, or exposed to water. Call for service immediately if any of these conditions exist.

Maintain the equipment to keep it in good working condition, as described in the Maintenance section of the assembly and maintenance guide. Inspect the equipment for incorrect, worn, or loose components, and then correct, replace or tighten prior to use.

If you plan to move the equipment, obtain help and use proper lifting techniques.

Equipment Weight Restrictions: Do not use the treadmill if you weigh more than 500 pounds (225 kg). If you weigh more than 350 pounds (160 kg), do not run on the treadmill. For all other fitness equipment, the weight limit is 350 pounds (160 kg).

Image 7
Contents Operating and Maintaining the P20 Console Page Page Trademark Note Edition InformationIntellectual Property Notice Safety Precautions Important Safety InstructionsOperating and Maintaining the P20 Console Important Safety Instructions Product Recycling and Disposal Hazardous Materials and Proper DisposalRadio Frequency Interference RFI Safety Approvals for Cardiovascular EquipmentRegulatory Notices for Cardiovascular Exercise Equipment Cardiovascular Type EquipmentEuropean Applications Industry CanadaElectrical Recommendations 120 V and 240 V Treadmills North American 120-volt, 20-amp power receptacleIEC-320 C13 and C14 plugs Obtaining ServiceTable of Contents Operating and Maintaining the P20 Console Activating the Console for Self-Powered Equipment Activating the Console for Self-Powered EquipmentGetting Started Optional Use of the Power Adapter Setting Up the Console Identifying Parts of the Console  Press GO or Programs to Start scrolls in the text display Welcome StateInput Up Enter Viewing the Odometer Informational MenuOdometer To view the odometer informational menuEvent Log Event Description of Event Number Hour MeterBase Software Viewing the Club Settings MenuBoot Software Lower SoftwareMax Pause Time Club Setting Values LanguageTo view the Club Settings menu Max Cool Down TimeUnit of Measure Default Workout TimeMax Resistance Bike, AMT Max Workout TimePrograms Enter Input Down Input Up Safety Code TreadmillSegments EFX Introducing Users to the P20 Console Using the Touch Heart Rate FeatureHeart rate target zones To use a chest strap transmitter Using a Chest Strap TransmitterRestart switch Using the Treadmill Safety ClipTreadmill Auto Stop Automatic Stop Function Attaching the safety clipTo test your heart rate Using SmartRateStarting a Workout To begin using a program Starting a Preset Programmed WorkoutEntering Personal Data Terminating Data Entry Pausing and Restarting an Exercise SessionTo enter personal data Pending Shutdown Self-Powered Equipment Paused Externally Powered EquipmentEnding a Session Controlled Metrics Understanding MetricsOperating and Maintaining the P20 Console Manual ProgramsInterval 1-1 and Interval Weight LossHill Climb Basic Heart Rate ControlRandom Cross CountryAerobic Cleaning the Console and Display MaintenanceTo remove dust and dirt from the console Operating and Maintaining the P20 Console Page Precor Incorporated Assembling and Maintaining Elliptical Fitness Crosstrainers Page Page 300712-341 rev G Important Safety Instructions Page Important Safety Instructions Educating Users Regulatory Notices for the Rfid Module Equipment PVS and P80 Regulatory Notice Per FCC rules, changes or modifications not Obtaining Service Obtaining Updated Documentation Assembling the EFX Commercial Cardiovascular Equipment Limited Warranty Assembling the EFX To prepare the EFX for assemblyHardware Kit not to scale Installation RequirementsFasteners Handlebar bolt wrench To begin assembly Performing the AssemblyRequired Tools Route the cable Attach the upright support to the base frame Cable connection points inside EFX base Lift cover replacement Rear view of console attachment To mount the center column support on the frameAttachment of center column support To tighten the fasteners properlyTighten the back fasteners on the upright supports Important Attach one handlebar at a time To attach the handlebarsHandrail attachment detail To tighten the handlebars completelyAttach the outer handlebar caps To attach the upright support covers To attach the water bottle holderTo level the unit Leveling the EFXBreaking in the Equipment Threading the Cable Assembly P80 Installing the ConsoleRemoving the access cover from the P80 console To thread the cable assemblyConsole positioning on base unit Cable connections, P80 console Connecting Cables P80P80 internal cable connections Cable Connector Type Circuit To connect the television cable Connecting the Television CableConnecting the Ethernet and base unit data cables Connecting the Ethernet and Base Unit Data CablesConnecting the Power Cable Connecting the Heart Rate Sensor CableTo complete the installation Completing the Console Installation P80Threading the Cable Assembly P30 and P20 Console positioning on base unit Cable connections, P30 console Connecting Cables P30P30 internal cable connections Cable Connector Type Connecting Cables P20 Completing the Console Installation P30 and P20 To verify that the heart rate display is operational Verifying That the Heart Rate Display Is OperationalDaily Cleaning Daily Inspection Monthly Maintenance Weekly MaintenanceMoving the Equipment Storing the Chest StrapLong-Term Storage Rate of Motion Self-Powered FeaturesInformational Displays Prior to Shutdown Symptoms of a Low BatteryOptional Power Adapter Kit Using the Optional Power AdapterReplacing the Battery Limited Warranty Commercial Cardiovascular Equipment Limited WarrantyWarranty Periods and Coverage Conditions and Restrictions Exclusive Remedies Complete this portion and keep for your records Exclusion of Consequential and Incidental DamagesPage EFX 8x3 PAG/OM 300712-341 rev G, en