Mitsubishi Electronics WD-73C9, WD-52527 Rear Terminal Cover Removal, Power Supply Shield Removal

MODELS: WD-60C9 / WD-65C9 / WD-73C9 / WD-60737 / WD-65737 / WD-73737 / WD-82737

WD-65837 / WD-73837 / WD-82837

CHASSIS REMOVAL & DISASSEMBLY (Continued)

PG2

(Rear)

C(V41+)

RS232C

A

D

D

Rear Terminal Cover Removal

1)Remove nut (A) from the ANT input.

2)Disconnect connector PG2 from the rear of the RS232C assembly (V41+ only).

3)Remove screws (C) and (D).

4)Remove the Terminal Cover from the chassis.

POWER

SUPPLY

SHIELD

Power Supply Shield Removal

1)Remove screw (A).

2)Remove the Power Supply Shield from the chassis.

PWB-POWER Removal

1)Remove screws (B).

2)Disconnect all cables from the PWB-POWER.

3)Lift the PWB-POWER from the chassis.

PWB-POWER Installation

NOTE: The PWB-POWER should be re-installed so the Heat Sink is opposite the Power Supply Shield.

PWB

POWER

B

A

HEAT SINK

Page 8