Mitsubishi Electronics WD-82837, WD-52527, WD-73837 Top Chassis Brackets Removal, PWB-MAIN Removal

MODELS: WD-60C9 / WD-65C9 / WD-73C9 / WD-60737 / WD-65737 / WD-73737 / WD-82737

WD-65837 / WD-73837 / WD-82837

CHASSIS REMOVAL & DISASSEMBLY (Continued)

TOP CHASSIS	A	A
BRACKETS

A

Top Chassis Brackets Removal

NOTE: Removal of the Power Supply Shield and PWB-POWER is not required to remove the Top Chassis Brackets.

1)Remove screws (A).

2)Disconnect all cables from the PWB-POWER.

3)Lift the Top Chassis Brackets from the chassis.

PWB-MAIN Removal

1)Disconnect all cables to PWB-MAIN.

2)Remove screws (A) from the DVI connector.

3)Remove screws (B) from the Side Terminals.

4)Remove screw (C) from the Side HDMI connector (V41+ only).

5)	Remove screws (D).	B
6)	Lift the PWB-MAIN out of the
	chassis.

C

(V41+)

A

DVI

D

HDMI

PWB-MAIN Installation

1)Install screws (A) (B) and (C) first.

2)Then install screws (D).

3)Perform “Restore Engine Data From Backup” (See Data Transfer in Service Adjustments section).

4)Perform “Restore Geometry Data From Backup” (See Data Transfer in Service Adjustments section).

Page 9