Chapter 5. Operating Other Devices with the Remote Control | 63 |
Programming the Remote Control
Method 1: Code Entry
1.Move the slide switch at the top of the remote to the position for the product you want to control. Refer to the table below. Only one of each device type can be controlled in each
Switch Position | Affected Device |
|
|
CABLE/SAT | Cable Box |
| DTV Receiver |
| Satellite Receiver |
|
|
VCR | VCR |
| DVR |
| Laser Disc Player |
| DVD Player/Recorder |
|
|
DVD | DVD Player/Recorder |
| DVR |
| Laser Disc Player |
| VCR |
|
|
AUDIO | A/V Receiver |
| Audio Amplifier |
| CD Player* |
|
|
2.Press and hold POWER on the remote control for several seconds until the button blinks twice and goes off.
3.Release the POWER button.
4.Enter the first
•The POWER button blinks twice when you start to enter the code and then once for each additional keypress.
•The POWER button blinks twice when you finish entering a valid code.
•Move the slide switch to another position if you need to start over or wish to exit programming mode.
5.Point the remote control at the equipment and press POWER. If the product has no power on/off function,
press a different key, such as 
(PLAY), 
(STOP), VOL 
, or MUTE.
•If the equipment responds, the remote control is properly programmed to operate the equipment.
•If the equipment does not respond, repeat steps
IMPORTANT
You may need to reprogram the remote control after changing the batteries.
6.Once you have found the correct code, write it in the space below for future reference.
Switch Position | Device Type | Code |
|
|
|
CABLE/SAT |
|
|
|
|
|
VCR |
|
|
|
|
|
DVD |
|
|
|
|
|
AUDIO |
|
|
|
|
|
Method 2: Code Search
In this method of programming, you step through the remote control’s internal code library to find the correct code for your A/V product.
1.Move the slide switch at the top of the remote control to the correct position for the product. See the table under “Method 1.”
2.Press and hold POWER on the remote control for several seconds until the button blinks twice and goes off.
3.Press keys 9 9 1
4.Press the number 1, 2, or 3 depending on the slide- switch position and the table below.
Switch Position | Number |
|
|
CABLE/SAT | 1 |
|
|
DVD, VCR | 2 |
|
|
AUDIO | 3 |
|
|
5.Press CH
and POWER repeatedly until the product responds by powering on or off. You can press CH
to move backward through the code library if needed.
NOTE: If the product has no power on/off function, check for a response using a different function. Press
(PLAY), 
(STOP), VOL 
, or MUTE and then re- peatedly press CH 
/
to check for a response.
6.When the product responds, press ENTER to set the code.
Code Verification
To determine the code programmed for any position of the slide switch:
1.Move the slide switch to the position you wish to verify.
2.Press and hold POWER on the remote control for several seconds until the button blinks twice and goes off.
3.Press keys 9 9 0
4.Press 1 and count the blinks of the power button. Write down the number of blinks as the first digit of the code.
5.Repeat step 4 for the second, third, fourth, and fifth digits of the code.