Mitsubishi Electronics WD-52527 Front-Panel Indicator Lights, Indicators, Power/Timer Indicator

Front-Panel Indicator Lights

SYSTEM			P	OWE	R
	RESET	LAMP STATUS TIMER

< <

VO L

> >

<

ADJ UST <

C H

>

>

FO

RMAT

M

E

N

U

G

U

D

E

D

EV

I

C

E

ENTER

M

EN

U

CAN

C

EL

Indicators

Refer to the following tables for explanations of the front-panel indicator lights.

Power/Timer Indicator

Indicator Color	TV Condition		Additional Information
None (indicator off)	TV is powered OFF.		Normal operation.
Green, steady	TV is powered ON.		Normal operation.
Green, rapid blinking	1.	TV just plugged into AC outlet.	Wait until blinking stops before turning on
			(approximately 1 minute). Normal operation.
	2.	AC just restored after power failure.	Wait until blinking stops before turning on
			(approximately 1 minute). Normal operation.
	3.	TV Rebooting after System Reset	Wait until blinking stops before turning on
	used.		(approximately 1-2 minutes). Normal operation.
	4.	TV Rebooting after power	Wait until blinking stops before turning on
	fluctuation or receiving abnormal		(approximately 1 minute). Normal operation.
	digital signals from digital channel,
	CableCARD™, or digital device.
	5.	You have begun the procedure to	For detailed information, see the instructions
	update software from an authorized		that accompany the authorized software update.
	flash memory device.		Important: Do not use non-authorized software at
			any time.
Green, slow blinking	TV powered off and automatic on-		Normal operation. TV can be turned on at any time.
	timer is set.

Lamp Indicator

Indicator Color	TV Condition	Additional Information
None (indicator off)	Normal TV on or standby condition.	Normal operation.
Green, rapid blinking	TV just powered off and lamp is	Begins to blink 30 seconds after turning off TV. TV
	cooling.	can be turned on before it begins to blink or after the
		blinking stops, but not while the indicator is blinking.
		Normal operation.
Yellow, steady	Lamp nearing end of useful life.	This is a recommendation to have a new lamp ready
		before the current lamp stops illuminating. See
		Appendix H for ordering information.
Yellow, blinking	1. Lamp access door is open or not	TV will not operate until lamp access door is secure.
	secure.	See Appendix H for installation information.
	2. No lamp installed.	TV will not operate without a lamp. See Appendix H
		for installation information.
Red, steady	Lamp no longer illuminates and has	Replace the lamp. The TV will not operate when
	reached the end of the lamp life.	the lamp no longer illuminates. See Appendix H for
		installation information.

16 Chapter 1. Television Overview