Mitsubishi Electronics WD-52527 Connecting a Wall Outlet Cable or Cable Box, Standard Cable Box

Connecting a Wall Outlet Cable or Cable Box

Wall Outlet Cable

(can be used with a CableCARD™)

Figure 1

It is very important to connect the incoming cable for your primary viewing source to ANT-1, especially for CableCARD™ use.

1.Connect the primary incoming coaxial lead cable to ANT-1 MAIN on the TV back panel.

2.For an optional secondary antenna source, connect an antenna (or cable) to ANT-2 AUX.

3.If you have subscribed to a CableCARD™ service, the CableCARD can now be inserted into the CableCARD SLOT. Using a Phillips screwdriver, remove the CableCARD cover screws. Insert the CableCARD, then replace the cover and screws. Additional CableCARD information is on page 20.

			57 CBDL QBOFM TFDUJPO
	DTV/CABLE/
	VHF/UHF
	USE WITH				DIGITAL
	CableCARDTM				AUDIO		CableCARD™ USE WITH ANT 1 CARD TOP
		ANT 1 / MAIN		ANT 2 / AUX OUTPUT
 1SJNBSZ
8BMM 0VUMFU						 $BCMF$		"3%5. 4-05
$BCMF							DPWFS SFNPWFE

Standard Cable Box

(analog cable box, other than an HDTV cable box, compatible with PIP/POP)

Figure 2

3 coaxial cables and one two-way RF splitter are required. These are not included with the TV.

Note: See page 29 to connect an HDTV cable box.

1.Connect the incoming cable to IN on an RF splitter.

2.Connect one coaxial cable from OUT on the RF splitter to ANT-1 MAIN on the TV back panel.

3.Connect one coaxial cable from OUT on the RF splitter to IN on the analog cable box.

4.Connect one coaxial cable from OUT on the cable box to ANT-2 AUX on the TV back panel.

5.After the cable box is connected to ANT-2 AUX as shown, open NetCommand and go to the RF Connection for Cable screen and do the following:

a.Check the RF check box.

b.For antenna, select ANT-2.

c.For Channel, select the channel to which the TV must be tuned for your cable box. The default channel is 3.

When this setup is complete, you can use the TV remote control to change channels on the cable box.



0QUJPOBM
4FDPOEBSZ

"OUFOOB
PS
$BCMF

Figure 1. Wall Outlet Cable

	RF splitter
			
		*55&3	065
	*/	580 8": 41-	065
*ODPNJOH

$BCMF



$BCMF
#PY

CBDL
QBOFM
TFDUJPO



57
CBDL
QBOFM
TFDUJPO

DTV/C BLE/

VHF/UHF

USE WITH

CableCARD

ANT 1 / MAIN ANT 2 / AUX

 

IMPORTANT

*/

065

Figure 2. Connecting a Cable Box

Additional connection cables are not provided with the TV. They are available at most electronic stores.

Note: To use a cable box connected to ANT-2 as shown above, you must make the noted NetCommand changes. The changes are required to change the NetCommand cable-box default connection (Component-1) to the actual connection (ANT-2).

Chapter 2. Connecting 23