Record Menu
Record
Figure 14
The Record menu allows you to manually set up recordings, view the record list, and set defaults for your recording devices.
.
Figure 14. Record Menu
Recording Setup
Figure 15
Figure 15. Recording Setup screen
The recording Setup menu is where you tell the TV what, where, and when to record. There are two ways to open the Recording Setup menu:
•by selecting Record from the Record menu.
•by pressing REC on the remote control.
Your TV is able to start and stop recordings automatically and send the signals from one external playback device to another external recording device. It is also able to convert digital channels and IEEE 1394 device signals to analog signals that can be recorded on NetCommand- compatible analog VHS and
You can schedule the recording to take place at a later time and program the recording duration for a minimum of 30 minutes and a maximum of 6 hours (in
When a digital recording is being made, the TV will direct the signals to the recording device using the IEEE 1394 cable. In the case of an analog recording (as to a VCR) the TV converts the digital signals to analog format and sends the analog output to the VCR through the RECORD OUTPUT jacks.
During the recording, the TV can be powered Off.
To prevent recording of unwanted material while recording to a VCR or A/V disc, press PAUSE to temporarily stop recording. Press PAUSE again to resume recording.
You cannot record from an analog channel or device or a VHS or
Recording Now
Can be used when viewing Antenna 1 or 2, an IEEE 1394 device, or a device connected to Input 1, 2, or 3.
To initiate recording now:
1.Press REC (record) on the TV remote or press ENTER if the Record menu is displayed.
2.Review the destination device (VCR) and duration. Change if necessary.
3.Press REC a second time to initiate recording.
Time-Delayed Recording
To initiate a
1.Press REC (record) on the TV remote or press ENTER if the Record menu is displayed.
2.Press ADJUST 
or 
to select the channel, device to record to, duration time, start time (press ENTER after selecting hour to set minutes) and day.
3.Select Add and press ENTER to add the recording
to the record list. If your selection is successful, a confirmation message will be displayed. If you pick overlapping times, day(s), or destination devices, you will see a message stating there is a conflict.
4.To exit, press HOME on the TV remote after all recordings have been added.
IMPORTANT
Recordings scheduled on this screen are independent of recordings scheduled through TV Guide On Screen®. Recordings scheduled with TV Guide On Screen have priority if there is a conflict between the two recording schedules.
66 Chapter 5. TV Menu Screen Operations