Mitsubishi Electronics WD-52527 manual NetCommand Initial Setup, NetCommand Information Screen

NetCommand® Initial Setup

IMPORTANT

You may use your TV without setting up NetCommand or the TV Guide On Screen® system. To set up at a later time, choose the NetCommand menu from the Main menu, then select Initial. The TV Guide On Screen system is set up from the NetCommand menu.

When you first power On your new Mitsubishi TV, the initial setup screens appear. The process allow you to quickly set up NetCommand and the TV Guide On Screen® system. Most IR remote control signal formats can be learned by NetCommand.

NetCommand (Information) Screen

Figure 2

The NetCommand (Information) Screen describes how to start or delay the initial NetCommand and TV Guide On Screen setup. This screen displays automatically the first time you power On your new TV, after the Welcome screen.

Welcome Screen

Figure 1

When you first turn on your TV, the NetCommand Welcome screen displays and asks you to select either English or Spanish as the language for the on-screen menus. The default language is English. To change Language later, select Setup in the Main Menu. Selecting Cancel at this screen will cause the default language (English) to be selected.

Figure 1. Welcome screen

Figure 2. Information screen

Select Next> and press ENTER to start the initial setup.

IMPORTANT

NetCommand must be set up and the IR emitters properly placed for your cable box and VCR so the TV Guide On Screen system can control these devices.

If the NetCommand Setup is cancelled before it’s completed, you can restart the NetCommand setup by

1.A press of TV MENU on the remote control to display the TV Main menu.

2.Select NetCommand. The available options will be: Add, Review, Guide or Initial. Change and Delete will be grayed out.

3.Press ADJUST , , or to select Initial.

4.Press ENTER. The Device Setup screen (shown on the next page) displays.

40 Chapter 3. NetCommand Setup and Editing