Mitsubishi Electronics WD-62628, WD-52628, WD-73727 manual Outputs

Page 101

Appendix A: Specifications, continued

Audio Inputs: Qty. 7 pairs

RCA Pin Plug 500 mV (full scale), 43-k ohm

 

 

 

 

Outputs

 

 

 

Video, Qty. 1

Video: RCA Pin Plug 1.0 Vp-p, 75-ohm

Signal Type

NTSC 480i only

 

 

 

 

 

Audio:, Qty. 2 pairs

RCA Pin Plug, 500 mV rms + 200 mV (full scale) for analog sources, 1.5

 

Vrms + 0.5 Vrms (full scale) for digital sources.

 

 

 

 

Digital Interfaces:

 

 

 

 

 

 

 

Digital Audio Output, Qty. 1

RCA Pin Plug, Signal Type, Dolby Digital, PCM

IEEE 1394, Qty. 3

IEEE 1394 Four Pin type Terminal, S400

(1 front, 2 rear)

 

 

 

 

 

 

 

Audio/Speakers

Qty. 2 woofers 5.5" x 2.2"; Qty. 2 Tweeters 1.5" round

 

 

 

 

 

 

 

 

Dimensions:

WD-52628

 

34" H x 49.6 " W x 18.6 " D, 121 lbs.

 

 

 

 

 

WD-62628

 

40.5" H x 58.3" W x 19.9" D, 133 lbs.

 

 

 

 

 

WD-73727

 

44.8" H x 69.9" W x 21.5 " D, 188 lbs.

 

 

 

 

 

 

 

Power Consumption

WD-52628

295 watts

 

 

 

 

WD-62628

295 watts

 

 

 

 

WD-73727

335 watts

 

 

 

 

NetCommand® IEEE 1394 System Compatibility:

This television is designed to conform to IEEE 1394 AV/C Software standards in effect at the time of development. This exciting new networking and control technology is designed to provide high-performance digital connections and product control, making the product easier to use.

Mitsubishi D-VHS VCRs are fully compatible with this TV in audio, video, and control.

As other manufacturers distribute products that use the IEEE 1394 AV/C standards, they will be responsible for developing products that meet the standards of the technology, as well as compatibility testing

with other products. Mitsubishi cannot be responsible for their efforts, and therefore cannot promise compatibility with these other products. Any compatibility problems with other manufacturers products should be brought to the attention of those manufacturers.

The HDMI input is compliant with EIA-861B standards for standard, extended and high definition video, digital audio and HDCP copy protection. HDMI input 1, however, is not intended for use with personal computers or devices outputting video signals with computer resolutions.

Appendices 101

Image 101
Contents TV Information Visit our website atStand Requirement TV Guide On Screen Access RequirementsFCC Declaration of Conformity Important Safeguards Important Safeguards Contents Mitsubishi DLP Projection Television Limited Warranty Mitsubishi Digital Electronics America, Inc Our ThanksTV Accessories Special Features Front Control Panel Remote Control      TV AccessoriesSpecial Features Front Control Panel Front-Panel Indicator Lights Lamp IndicatorModels WD-52628, WD-62628 Model WD-73727Reset Status IndicatorPower/Timer Indicator Overview Remote ControlCare Battery InstallationSleep Timer TV Back Panel IR Emitter NetCommandComponent 1, 2, and 3 Inputs Input 1DTV Link/IEEE Hdmi 1CableCARD Slot Digital Audio OutputCard Compatibility Memory Card Reader and Front-Panel InputsMemory Card Input 3 and Ieee Reader Input/Output Input 3 and Ieee 1394 Input/OutputTV Reset Menu System Reset ButtonDemo Mode Additional InformationConnecting Stereo and/or digital audio cables AV Receiver Connecting External Devices and NetCommand SetupCableCARD Technology Using a CableCARDUsing a CableCARD Wall Outlet Cable Connecting a Wall Outlet Cable or Cable BoxStandard Cable Box Can be used with a CableCARDAntennas with Separate UHF and VHF Leads Antenna with a Single LeadFor antennas with flat twin leads For cable or antenna with coaxial lead$BCMF VCR to an Antenna or Wall Outlet Cable Audio & VideoVCR to a Cable Box Audio & Video Connecting a VCR to a Cable Box Audio & VideoTo connect an analog A/V receiver Receiver Stereo SystemSatellite Receiver or Other Device with S-Video DVI Device DVD Player with Component VideoHdmi Device Hdtv Cable Box or Satellite Receiver with Component VideoComputer with an Hdmi Monitor Output Connecting a Computer with an Hdmi or DVI Monitor OutputComputer with a DVI Monitor Output To view PC video on the TVConnecting IR Emitter NetCommand Connecting the IR Emitter NetCommandCompatible Ieee 1394 Devices Connecting Compatible Ieee 1394 DevicesWhen Connecting Ieee 1394 Devices Connection Styles Pin-Style vs -Pin-Style ConnectorsDirect Device-To-Device Style Hub Connection StyleHelpful Hints for NetCommand Connections Page NetCommand Setup and Editing NetCommand Introduction NetCommand Pre-Memorized Devices Using the Remote Control with NetCommandReceiver Cable Box SAT Satellite DVD Player ReceiverNetCommand Setup On-Screen Buttons 3D Graphical Menu System Remote Control ButtonsNetCommand Information Screen NetCommand Initial SetupSetup Reminder Welcome ScreenTV Guide On Screen System Setup Device Setup ScreenFinish Screen Review ScreenReceiver Inputs Edit NetCommand Add an A/V ReceiverReceiver Screen Receiver AVR Learn Screen Receiver AVR Input Learn ScreenAudio Output to AVR Screen Name ScreenAdd Screen Edit NetCommand Add DevicesEdit NetCommand Screen Device Learn Screen Device ScreenConnection for Device Screen Device Advanced Learn ScreenIR Code for Device Screen VCR for Recordings ScreenRF Connection for Cable Screen Delete Device Screen Edit NetCommand Change or Delete DevicesChange Device Screen Ieee 1394 Devices and NetCommand Control Adding Ieee 1394 Devices Automatically Adding Ieee 1394 Devices AutomaticallyNew 1394 Device Screen Name for 1394 Device ScreenConnection Screen Ieee 1394 Device Type ScreenPage NetCommand Functions PIP Device Selection Menu Device Selection MenuDevice Menu Using the Device Menu Button to Display MenusCableCARD Menu IR Controlled DevicesGuide Button Using the Guide Button to Display ChannelView and MenusGuide and the Device Selection Menu Guide and the Record To MenuNetCommand-Controlled Recordings Restrictions for Traditional VCRs Copy-Protected MaterialSetting up a Non-Recording Peer-to- Peer Connection What is a Peer-to-Peer Connection?Cancelling a Peer-to-Peer Connection Peer-to-Peer ConnectionsTrack List Screen Using A/V DiscsDisc Search TV Menu Operations Main Menu Language Setup MenuMemorize Channels ClockSoftware Version TimerLamp Reminder Remote Control Transport Buttons NetCommand MenuEdit Icon OrderTime-Delayed Recording Recording SetupRecord Menu RecordSetting Up Analog Recordings with TV Guide On Screen Default Digital Record DeviceTV Guide On Screen and the Record List Analog RecordingsChannel Menu SQV SuperQuickView Signal StrengthCaptions Menu Digital SettingsAnalog Captions BackgroundSize FontsColor Opacity FontSetting V-Chip Options Setting a Pass CodeChip Lock Menu Chip Lock Menu OverviewLock by Time V-CHIP ButtonFront Button Lock Bypassing V‑Chip Lock and Lock by TimeContent Categories Chip Signal InformationPrograms without V-Chip signals Chip RatingsAudio/Video Menu Analog and Digital Audio Settings Audio SettingsAnalog-Only Audio Settings Digital-Only Audio SettingsPC Video Settings Video SettingsVideo Settings Page MediaCommand and Memory Card Playback Additional FeaturesMemory Card Slots MediaCommand and Memory Card PlaybackMedia Command and Memory Card Playback Operation of PIP and POP TV Display Formats Signal DefinitionsDVD Definitions Format Definitions57%JTQMBZ PC Viewing PC resolution XGA selectionPC Display Formats Signal Format 16 X 9 StandardSignal Format Standard Zoom Troubleshooting General TV Operation Symptom Suggested SolutionTroubleshooting Position PictureSound IndicatorsDevice Ieee 1394 DevicesTV Guide On Screen Page Appendix G Cleaning and Service Appendix a SpecificationsInputs Appendix a SpecificationsTV Specifications Outputs Analog Program Appendix B On-Screen Information DisplaysDigital Program Digital Ieee 1394 DeviceDeactivating the Front Button Lock Appendix C Bypassing the V-Chip LockBypassing the V-Chip Lock This page intentionally blank Programming the Remote to Control NetCommand A/V Products Appendix D Remote Control Programming CodesReceivers Cable BoxesVCRs DVD PlayersSatellite Receivers/SAT/DTV Cable/SAT/DTV position TV positionVCR position DVD positionNetCommand Compatible Traditional Devices Analog Appendix E Device Control with NetCommandWhen an Ieee 1394 Device is Viewed or Played Appendix F NetCommand Specialized Device Keys Appendix G Cleaning and Service Do not touch the glass parts of the lamp cartridge Appendix H Lamp Cartridge ReplacementWash Your Hands THOROUGHLY, AS this Lamp Contains Mercury Source device Appendix I Recording and Viewing CombinationsDigital VCR or A/V Disc Connected to IEEE-1394 Port Trademark and License Information Mitsubishi TV Software 118 Mitsubishi DLP Projection Television Limited Warranty119 This Limited Warranty does not CoverIndex IndexIndex Page Page Website Mail MDEAservice@mdea.com
Related manuals
Manual 86 pages 7.9 Kb