Mitsubishi Electronics WD-52628, WD-73727, WD-62628 manual Appendix G Cleaning and Service

Page 111

Appendix G: Cleaning and Service

IMPORTANT

DO NOT use any kind of abrasive cleaner on the surface of the TV screen.

Cleaning

Normally, light dusting with a dry, non-scratching duster will keep your TV clean. If cleaning beyond this is needed, please use the following guidelines:

First, turn off the TV and unplug the power cord from the power outlet.

Top and Sides of the TV:

•Gently wipe down your TV with a soft, non-abrasive cloth such as cotton flannel or a clean cloth diaper, lightly moistened with water. Dry with a second dry, soft, non-abrasive cloth.

•For oily dirt, add a few drops of mild liquid detergent, such as dishwashing detergent, to the water used to moisten the cloth. Rinse with a second cloth moistened only with water. Dry with a third dry, soft, non-abrasive cloth.

Screen:

•Follow the instructions for the top and sides, however, wipe gently in an up and down motion, following the grooves in the screen.

•Clean the entire screen evenly, not just sections of the screen.

•Do not allow liquid to drip down the grooves of the screen, as some liquid may enter the TV between the screen and the screen frame.

•You may purchase Mitsubishi Screen Cleaner, part number CLEANER-VSS, by calling (800) 553-7278.

General Cleaning Warnings:

•DO NOT allow liquid to enter the TV through the ventilation slots or any crevice.

•DO NOT use any strong or abrasive cleaners as these can scratch the surfaces.

•DO NOT use any cleaners with ammonia, bleach, alcohol, benzine, or thinners as these can dull the surfaces.

•DO NOT spray liquids or cleaners directly on the TV’s surfaces.

•DO NOT scrub or rub the TV harshly. Wipe it gently.

Service

If you are unable to correct a problem with your TV, consult your Mitsubishi dealer or a Mitsubishi Authorized Warranty Service Center.

•DO NOT adjust any controls other than those described in this Owner’s Guide.

•DO NOT remove the protective back cover of your TV.

Menus not described and shown in this owner’s guide are designed for factory use and for authorized service personnel. Damage caused to the TV by non-authorized changes or changes to these menus made by non-authorized persons are not covered under warranty.

Appendices 111

Image 111

Contents TV Information Visit our website atStand Requirement TV Guide On Screen Access RequirementsFCC Declaration of Conformity Important Safeguards Important Safeguards Contents Mitsubishi DLP Projection Television Limited Warranty Mitsubishi Digital Electronics America, Inc Our ThanksTV Accessories Special Features Front Control Panel Remote Control TV AccessoriesSpecial Features Model WD-73727 Front-Panel Indicator Lights Lamp IndicatorFront Control Panel Models WD-52628, WD-62628Status Indicator Power/Timer IndicatorReset Overview Remote ControlBattery Installation Sleep TimerCare Input 1 IR Emitter NetCommandTV Back Panel Component 1, 2, and 3 InputsDigital Audio Output Hdmi 1DTV Link/IEEE CableCARD SlotCard Compatibility Memory Card Reader and Front-Panel InputsMemory Card Input 3 and Ieee Reader Input/Output Input 3 and Ieee 1394 Input/OutputAdditional Information System Reset ButtonTV Reset Menu Demo ModeConnecting Stereo and/or digital audio cables AV Receiver Connecting External Devices and NetCommand SetupUsing a CableCARD Using a CableCARDCableCARD Technology Can be used with a CableCARD Connecting a Wall Outlet Cable or Cable BoxWall Outlet Cable Standard Cable BoxFor cable or antenna with coaxial lead Antenna with a Single LeadAntennas with Separate UHF and VHF Leads For antennas with flat twin leads$BCMF VCR to an Antenna or Wall Outlet Cable Audio & VideoVCR to a Cable Box Audio & Video Connecting a VCR to a Cable Box Audio & VideoReceiver Stereo System Satellite Receiver or Other Device with S-VideoTo connect an analog A/V receiver DVI Device DVD Player with Component VideoHdmi Device Hdtv Cable Box or Satellite Receiver with Component VideoTo view PC video on the TV Connecting a Computer with an Hdmi or DVI Monitor OutputComputer with an Hdmi Monitor Output Computer with a DVI Monitor OutputConnecting IR Emitter NetCommand Connecting the IR Emitter NetCommandConnecting Compatible Ieee 1394 Devices When Connecting Ieee 1394 DevicesCompatible Ieee 1394 Devices Hub Connection Style Pin-Style vs -Pin-Style ConnectorsConnection Styles Direct Device-To-Device StyleHelpful Hints for NetCommand Connections Page NetCommand Setup and Editing NetCommand Introduction Receiver Using the Remote Control with NetCommandNetCommand Pre-Memorized Devices Receiver Cable Box SAT Satellite DVD PlayerNetCommand Setup On-Screen Buttons 3D Graphical Menu System Remote Control ButtonsWelcome Screen NetCommand Initial SetupNetCommand Information Screen Setup ReminderTV Guide On Screen System Setup Device Setup ScreenFinish Screen Review ScreenEdit NetCommand Add an A/V Receiver Receiver ScreenReceiver Inputs Receiver AVR Learn Screen Receiver AVR Input Learn ScreenAudio Output to AVR Screen Name ScreenEdit NetCommand Add Devices Edit NetCommand ScreenAdd Screen Device Learn Screen Device ScreenConnection for Device Screen Device Advanced Learn ScreenVCR for Recordings Screen RF Connection for Cable ScreenIR Code for Device Screen Edit NetCommand Change or Delete Devices Change Device ScreenDelete Device Screen Ieee 1394 Devices and NetCommand Control Name for 1394 Device Screen Adding Ieee 1394 Devices AutomaticallyAdding Ieee 1394 Devices Automatically New 1394 Device ScreenConnection Screen Ieee 1394 Device Type ScreenPage NetCommand Functions PIP Device Selection Menu Device Selection MenuIR Controlled Devices Using the Device Menu Button to Display MenusDevice Menu CableCARD MenuGuide and the Record To Menu Using the Guide Button to Display ChannelView and MenusGuide Button Guide and the Device Selection MenuNetCommand-Controlled Recordings Restrictions for Traditional VCRs Copy-Protected MaterialPeer-to-Peer Connections What is a Peer-to-Peer Connection?Setting up a Non-Recording Peer-to- Peer Connection Cancelling a Peer-to-Peer ConnectionUsing A/V Discs Disc SearchTrack List Screen TV Menu Operations Main Menu Clock Setup MenuLanguage Memorize ChannelsTimer Lamp ReminderSoftware Version Icon Order NetCommand MenuRemote Control Transport Buttons EditRecord Recording SetupTime-Delayed Recording Record MenuAnalog Recordings Default Digital Record DeviceSetting Up Analog Recordings with TV Guide On Screen TV Guide On Screen and the Record ListChannel Menu SQV SuperQuickView Signal StrengthBackground Digital SettingsCaptions Menu Analog CaptionsOpacity Font FontsSize ColorChip Lock Menu Overview Setting a Pass CodeSetting V-Chip Options Chip Lock MenuBypassing V‑Chip Lock and Lock by Time V-CHIP ButtonLock by Time Front Button LockChip Ratings Chip Signal InformationContent Categories Programs without V-Chip signalsAudio/Video Menu Digital-Only Audio Settings Audio SettingsAnalog and Digital Audio Settings Analog-Only Audio SettingsVideo Settings Video SettingsPC Video Settings Page MediaCommand and Memory Card Playback Additional FeaturesMemory Card Slots MediaCommand and Memory Card PlaybackMedia Command and Memory Card Playback Operation of PIP and POP Format Definitions Signal DefinitionsTV Display Formats DVD Definitions57%JTQMBZ PC Viewing PC resolution XGA selectionSignal Format 16 X 9 Standard Signal Format Standard ZoomPC Display Formats Troubleshooting General TV Operation Symptom Suggested SolutionTroubleshooting Position PictureSound IndicatorsDevice Ieee 1394 DevicesTV Guide On Screen Page Appendix G Cleaning and Service Appendix a SpecificationsAppendix a Specifications TV SpecificationsInputs Outputs Digital Ieee 1394 Device Appendix B On-Screen Information DisplaysAnalog Program Digital ProgramAppendix C Bypassing the V-Chip Lock Bypassing the V-Chip LockDeactivating the Front Button Lock This page intentionally blank Cable Boxes Appendix D Remote Control Programming CodesProgramming the Remote to Control NetCommand A/V Products ReceiversDVD Players Satellite Receivers/SAT/DTVVCRs DVD position TV positionCable/SAT/DTV position VCR positionNetCommand Compatible Traditional Devices Analog Appendix E Device Control with NetCommandWhen an Ieee 1394 Device is Viewed or Played Appendix F NetCommand Specialized Device Keys Appendix G Cleaning and Service Do not touch the glass parts of the lamp cartridge Appendix H Lamp Cartridge ReplacementWash Your Hands THOROUGHLY, AS this Lamp Contains Mercury Source device Appendix I Recording and Viewing CombinationsDigital VCR or A/V Disc Connected to IEEE-1394 Port Trademark and License Information Mitsubishi TV Software 118 Mitsubishi DLP Projection Television Limited Warranty119 This Limited Warranty does not CoverIndex IndexIndex Page Page Website Mail MDEAservice@mdea.com

Related manuals

Manual 86 pages 7.9 Kb