NetCommand® Initial Setup
The initial setup screens that appear when you first power on your new Mitsubishi TV guide you through setup of NetCommand and the TV Guide On Screen® system. Most IR remote control signal formats can be learned by NetCommand.
Welcome Screen
Figure 1
When you first turn on your TV, the NetCommand Welcome screen displays and asks you to select either English or Spanish as the language for the
Figure 1. Welcome screen
NetCommand (Information) Screen
Figure 2
The NetCommand (Information) Screen describes how to start or delay the initial NetCommand and TV Guide On Screen setup. This screen displays automatically the first time you power On your new TV, after the Welcome screen.
Figure 2. Information screen
Select Next> and press ENTER to start the initial setup.
If the NetCommand Setup is cancelled before it’s completed, you can restart the NetCommand setup from the Setup Reminder screen (see below) or by doing the following:
1.Press TV MENU on the remote control to display the TV Main menu.
2.Select NetCommand. The available options will be Add, Review, Guide or Initial. Change and Delete will be grayed out.
3.Press ADJUST 
to select Initial.
4.Press ENTER. The Device Setup screen (shown on the next page) displays.
Setup Reminder
Figure 3
This screen only appears if you did not set up NetCommand when the TV was first turned on. The Setup Reminder screen displays for the next six times you power on the TV.
If you would like to set up NetCommand and/or the TV Guide On Screen system, select Next and press ENTER. If you do not wish to set up NetCommand and/or the TV Guide On Screen system, then select Cancel and press ENTER.
Figure 3. Setup Reminder screen
IMPORTANT
You may use your TV without setting up NetCommand or the TV Guide On Screen® system. To set up at a later time, choose the NetCommand menu from the Main menu, then select Initial. The TV Guide On Screen system is set up from the NetCommand menu.
42Chapter 3. NetCommand Setup and Editing