Mitsubishi Electronics WD-52628 Front Control Panel, Front-Panel Indicator Lights Lamp Indicator

Front Control Panel

The shaded buttons on the front control panel are duplicated on the remote control. The top row of labels shows the control functions when there are no TV menus displayed on the screen. The bottom row of labels shows the control functions when the TV menus are displayed on the screen or when a special function has been activated. See “Remote Control Overview” for further details on the functions of these buttons.

4:45&.

3&4&5 -".1





45"564





5*.&3

2 3 4 5 1 Models WD-52628, WD-62628

1	3	4	1	5	2	1 Model WD-73727
Front Control Panel
1. Shaded buttons duplicate buttons on the remote control				2. System Reset		3. Lamp indicator

4.Status indicator 5. Power/Timer indicator

4:45&.

3&4&5

If the TV does not respond to either the remote control or the front panel controls and/or does not power off, press the SYSTEM RESET button with a pointed item, such as the end point of a paperclip. The TV will turn off and the TIMER light will flash quickly for about one minute. When the TIMER light stops flashing, you may again turn on the TV. The changes you made the last time the TV was on before you used the SYSTEM RESET button may be lost. Any changes that you previously saved are not lost.

Front-Panel Indicator Lights

Lamp Indicator

Indicator Color	TV Condition	Additional Information
None (indicator off)	Normal TV on or standby condition.	Normal operation.
Green, rapid blinking	TV just powered off and lamp is	Begins to blink 30 seconds after turning off TV. TV
	cooling.	can be turned on before it begins to blink or after the
		blinking stops, but not while the indicator is blinking.
		Normal operation.
Yellow, steady	Lamp nearing end of useful life.	This is a recommendation to have a new lamp ready
		before the current lamp stops illuminating. See
		Appendix H for ordering information.
Yellow, blinking	1. Lamp access door is open or not	TV will not operate until lamp access door is secure.
	secure.	See Appendix H for installation information.
	2. No lamp installed.	TV will not operate without a lamp. See Appendix H
		for installation information.
Red, steady	Lamp no longer illuminates and has	Replace the lamp. The TV will not operate when
	reached the end of the lamp life.	the lamp no longer illuminates. See Appendix H for
		installation information.

12Chapter 1. Television Overview