Mitsubishi Electronics WD-73727, WD-52628, WD-62628 manual Device Screen, Device Learn Screen

Edit NetCommand®: Add Devices, continued

[Device] Screen	• Select “Other”, skip Learn and select Next>. This
Figure 17	will allow the device to appear and will allow
	NetCommand to switch inputs to use this device.
If you selected “None” for a device type during initial
	However, NetCommand will not be able to control
setup, you can later add a device with this screen. This
	this device. Later you may use the “Change” option
screen also opens when you select the Change option in
	in the Setup menu to learn the remote control signals.
the Edit NetCommand screen.
The sample screens here show the choices for adding a	After selecting Next>, the screens that follow are: the
	Name Screen (Figure 20), Connection screen (Figure
VCR; similar screens will appear for any satellite receiver,
	21) and specialized device screens (Figures 22-24),
DVD player, or cable box.
	ending with the Finish screen (Figure 27).

Figure 17. [Device] screen

Choose ONE of these options:

•Select a recognized manufacturer. The model number optimized for NetCommand will display at the bottom of the screen. If a number follows the manufacturer’s name, (example: Mitsubishi 1), this indicates additional models are optimized for that manufacturer. For many device types, non-listed models will operate in the same way as the listed models and you can still use the pre-loaded setting.

After selecting Next>, the screens that follow are: the Name Screen (Figure 20), Connection screen (Figure

21)and specialized device screens (Figures 22-24), ending with the Finish screen (Figure 27).

•Select “Other,” then highlight “Learn” and press ENTER. This will allow you to have NetCommand learn the remote control signals of this new device.

After selecting “Learn” and pressing ENTER, the screens that follow are: [Device] Learn screen (Figure 18), [Device] Advanced Learn screen (Figure 19), Name screen (Figure 20), Connection screen, (Figure

21)and specialized device screens (Figures 22-24), ending with the Finish screen (Figure 27).

[Device] Learn Screen

Figure 18

Shown only if “Learn” was selected

1.Press ADJUST to select the check box for each function to be learned.

2.Press ENTER and the function name will begin to flash to confirm the ready-to-learn status.

3.Press the button on the device’s remote control that corresponds to the selected function. A check mark will appear and the function name will stop flashing. This confirms the signal learned status.

4.To test the learned command, press the ENTER button on the TV remote while the learned function is still highlighted. The device should perform the selected function. The device needs to be turned on and the IR emitters properly placed for the test to be successful (see page 32 for IR emitter placement).

5.Repeat for each function to be learned.

6.To erase a learned function, highlight the check box for that function and press CANCEL.

7.When the function signals have been learned, press ADJUST to select Next> and move to the [Device] Advanced Learn screen.

NOTE: When learning the device’s remote control signals, point the device’s remote control at the TV screen.

Hint: If the device’s remote control uses a single button for both Power On and Power Off, don’t learn the Power Off function.

Chapter 3. NetCommand Setup and Editing 49