Searching For Your Code, Checking the Codes

NOTE: If the LED did not blink twice, repeat steps 2 through 4 and enter the same code again.

5.Aim the remote control at the device and press POWER once. It should turn off. If the device does not respond, repeat steps 2 through 4, trying each code for your brand until you find one that works. If it still does not work, try “Searching for Your Code”.

Searching For Your Code

If your device does not respond to the remote control after trying all codes listed for your brand, or if your brand is not listed at all, try searching for your code. For example, to search for a code for your TV:

1.Turn on your TV and on the remote control, press TV once.

2.Press and hold SET until the LED (red light) blinks twice, then release SET.

3.Enter 9 9 1. The LED will blink twice.

4.Select a test function from the list below or use the default test function (POWER) and skip step 4.

NOTE: The keys that can be used for the test function are 0, 1, 2, 3, POWER, VOL +, Play, Stop and MUTE.

5.Press CH+ to begin searching for your code. Stop the search when the device turns off or performs the function selected in step 4 (if other than POWER).

NOTE: In the search mode, the remote control will send IR codes from its library to the selected device, starting with the most popular code first. Every press of CH+ will send a new code. If you go past the code that performed the Test Function, you can go back by pressing CH‑.

6.To lock in the code, press and release the SET key. The LED blinks twice.

7.To search for the codes of your other devices, repeat steps 1 through 6, but substitute the appropriate device key for the device you are searching for in step 1.

Checking the Codes

If you have set up the remote control using the Searching For Your Code procedure, you may need to find out which four-digit code is operating your equipment. For example, to find out which code is operating your TV:

1.On the remote control, press TV once.

2.Press and hold SET until the LED (red light) blinks twice, then release SET.

3.Enter 9 9 0. The LED will blink twice.

4.To view the code for the first digit, press 1 once. Wait 3 seconds, count the LED blinks (e.g., three blinks = 3) and write down the number in the leftmost box in the TV code boxes. NOTE: If a code digit is 0, the LED will not blink.

5.Repeat step 4 three more times for remaining digits. Use 2 for the second digit, 3 for the third digit, and 4 for the fourth digit. Write down the code digits in the remaining TV code boxes.

6.To check for codes of other devices, repeat steps 1 through 5, but substitute the appropriate device key for each device you are checking. Write down the device’s code digits in the appropriate code boxes.