Install the Batteries
•Before you can operate the remote control, you must first install the batteries (included).
•Push down on the remote's back cover and slide towards the bottom to remove it.
•Insert two AA batteries (supplied), carefully noting the %" and
•When batteries are installed, slide the cover back into place (until it clicks into position).
•If the remote control acts erratically, replace the batteries. Typical battery life is six months to one year. We recommend using alkaline batteries for longer battery life.
•When you change the batteries, try to complete the task within three minutes. If you take longer than three minutes, the remote control codes for your VCR, DVD, and/or Cable Box may have to be reset (pages
,_5, b,:_ o 2 o 3
0 _ d)_ 0 _
°_ 0 _ 0 _ 0 _
0000
Remote Control Basics
Press the POWER button to turn the television on or off.
Make sure the TV/OATV switch is set to TV. Move the switch to CATV only if you need to operate a cable box.
Slide the VOR/DVD eeJeetor switch to VCR to control a VCR, slide to DVD to control a DVD player. Please see pages 22 to 24 for instructions on programming your remote control to operate a Cable box, VCR or DVD player.
Press the CH+ and CH= buttons to scan through the channels. Tap the CH+ or CH- button to move through the channels one channel at a time.
To move rapidly through the channels using JVO's Hyper Scan feature, press and hold CH+ or CH=. The channels will zip by at a rate of five channels per second.
Press VOL+ or VOL - to raise or lower the volume. An indicator bar will appear onscreen to show you the television volume level.
The OH+,/- and VOL+/- buttons are also used to navigate JVC's onscreen menu system.
You can directly access specific channels using the 10=key pad. For more information on remote control button features, see pages 53 to 59. For information on using the onscreen menus, see page 26.