Maintenance and Filter Cleaning
Lamp Replacement
When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the screen and LAMP REPLACE indicator lights yellow. Replace the lamp with a new one promptly. The timing when the LAMP REPLACE indicator should light is depending on the lamp mode.
WARNING:
TURN OFF THE UV LAMP BEFORE
OPENING THE LAMP COVER
Top Control
LAMP REPLACE indicator
Lamp replacement icon
CAUTION
Allow a projector to cool for at least 45 minutes before you open the Lamp cover. The inside of the projector can become very hot.
CAUTION
For continued safety, replace with a lamp of the same type lamp. Do not drop the lamp or touch the glass bulb! The glass can shatter and may cause injury.
Follow these steps to replace the lamp. | Lamp cover | |
| ||
1 | Turn off the projector and unplug the AC power cord. |
|
| Let the projector cool for at least 45 minutes. |
|
2 | Remove the screw that secures the lamp cover, and |
|
| then open the lamp cover. |
|
3 | Remove the two (2) screws that secure the lamp. Lift |
|
| the lamp out of the projector by using the handle. | Handle |
4 | Replace the lamp with a new one and secure the two |
|
| (2) screws. Make sure that the lamp is set properly. |
|
| Put the lamp cover back and secure it with the screw. |
|
5 | Connect the AC power cord to the projector and turn |
|
| on the projector. |
|
6 | Reset the lamp counter.. |
|
| See “Resetting the Lamp Counter” on the next page. |
|
Screw
Screws
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering, give the following information to the dealer.
● | Model No.. of your projector | : | |
● | Replacement Lamp Type No. | : |
|
59