Genie GDVRH-604, GDVRH-616, GDVRH-608 manual Tour Group, Communication settings

Page 75

2.1 Tour Group

A preset Tour Group allows a camera to move through a programmed sequence of PTZ presets.

1)Communication settings.

:Configure appropriate model and then enter the corresponding baud rate, PTZ ID (address). Please refer to the PTZ manufacturer’s instruction manual for proper jumper settings to match the protocol settings to the DVR.

2)Tour: There are 4 programmable Tours. Use the [-, +] buttons to change the values [Group 1 Group 2 Group 3 Group 4]

3)There is sub menu of each Tour group. The menus are displayed with options in the left-hand column and settings in the right hand column.

a. Group List: Each Tour Group can consist of up to 10 preset positions.

b. Preset no. : Enter the start preset no and stop preset.

c. Dwell Time: Set the pause between end of current preset and the start of the next preset.

d. Change: Add, modify or clear the Tour list using this option. f. Repeat the procedure in step b to d to add Tour list.

77

Image 75

Contents Digital Video Recorders Safety Precautions Contents VI. Setup Auto Back upFTP Log List Back up Playback Time SearchGo to Search Log List Search Manual Back upDisclaimer Page Regulatory Preventing MalfunctionPackage Contents Front Panel ControlsMENU, DIRECTION, ENTER, Cancel Channel Rear Panel ConnectorsAudio Output 1 connectors RCA Remote Controller Virtual Keypad for Mouse Control Camera, Monitor, Audio, Alarm sensor and Power cord II. Installation & ConnectionsConnection of N.O Normally Open Alarm inputs and Alarm outsConnection of N.C Normally Close PTZ and controller connection Connecting Single User with 2 DVR Configuration Disclaimer PC system requirement for Network connectionIII.QUICK Start Time & Date Setting Display Overview Recording ModeEvent Indicator IV.LIVE ViewingSpot Monitor indicate Status BarMulti-screen Display and Switch Sequencing Display Multi-screen Display and SequencingScreen Display Quick multi split mode change Quick button for multi screen DisplayRepositioning Zooming Spot Monitor LOG IN/OUT OperationNavigation the Menu Display VI. SetupMain SPOT1 SPOT2 SPOT3 SPOT4 Switch Setup Monitor ConfigureEvent EventCamera Video AdjustmentCommunication Settings PTZ Set UpCamera Title Motion Detection Setting Privacy Mask RecordApproximate File Size Record GeneralPAL Mode Resolution & Recording Speed SettingContinues /Normal Recording Event Recording Event Edit Schedule Continuous + Event Motion/Alarm RecordingChart Setup Mode Night Day No Rec Holiday SetupDisk Mode OFF Day Night No Rec Sun~Sat CustomDisk Manager SelectMirror Mirror on INT -A Link Record Disk Initialise for Back UpRecording Disk PRE-FAIL occurred before Alerts that may be a problemFind problem / need to replace Status ExplanationStatic IP NetworkExample Page Page Smtp Ddns Dynamic DNS Page Router & Port Forwarding Internet DHCP Device Alarm Control Manual stops for relay output and buzzer Buzzer USE PTZ Event System Time Account Channel PasswordUpdate Info T.Z. Menu VII. PAN/TILT Zoom ControlHow to Control PTZ Using a Mouse Preset & Tour Tour Group Auto Pan / Auto Tilt / Power Custom FunctionsPTZ Camera Model PAN/TILT/ZOOM Camera List Multi Channel Playback VIII.PLAYBACK /SEARCHPlayback Time SearchPreview Search Single Channel Playback Event Record Search Event Source Search Motion Area Search Single Channel Playback Go to Search Menu TAB Condition Log List SearchManual Back Up Internal DVD- R/W IX.BACKUPPage External USB HDD/ Memory Stick Back up Range SetupAuto Back Up FTP Log List Back Up Specification Revised June Appendix 1 Time Zone Chart Weee Symbol Information Memo