Maxtor 16Channel Stand Alone DVR Event Server Setup, Event Server Program, Event Server Type

SELECT : ▲▼, CHANGE VALUE : + -

CHAP. 5 Set Up

(5) EVENT SERVER SETUP :
IP ADDRESS : IP Address of PC that executes
	EVENT SERVER SETUP
EVENT SERVER PROGRAM.
IP PORT : PORT of PC that executes	IP ADDRESS	192.168.001.072
EVENT SERVER PROGRAM
	IP PORT	09988
EVENT SERVER TYPE :
	EVENT SERVER TYPE	OFF
It is the way to transmit data to SERVER	INTERVAL	---
By "OFF", "EVENT", "MINUTE“,	EVENT GMT TYPE	GMT+00:00
In case Event happens from DVR.

"EVENT“: It transmits by the number of EVENT.

"MINUTE“: It transmits each scheduled time.

INTERVAL: If EVENT SERVER TYPE is "EVENT"

User can select from 1~512.

If EVENT SERVER TYPE is "MINUTE“, User can select from 1 ~ 60 mins.

EVENT GMT TYPE : User can set currently installed location(DVR) of GMT.

2)RS-232C SETUP

User can control the DVR via RS-232C port. Connect DVR to PC via RS-232C port and control DVR using keyboard of PC.

This function is mainly for programmer who wants to control DVR as part of many devices connected to PC system, as in SI project.

	RS-232C SETUP
SPEED	115200
LENGTH	8
STOP BIT	1
PARITY	NONE

SELECT : ▲▼, CHANGE VALUE : + -

3) PANTILT SETUP

It is to set parameters for PTZ camera connected to DVR unit. DVR unit already includes all protocols of well-known PTZ cameras like PELCO D type PTZ camera, and user just select MODEL and set other parameters to control this PTZ cameras, using operation buttons on the front panel of DVR.

PANTILT SETUP			COMMAND SETTING
		CHANNEL		01
		MODEL		PELCO-D
		PTZ ID		000
COMMAND SETTING	￿ PTZ camera set	BAUDRATE		2400 BPS
		CMD DELAY		1 MSEC
SPEED SETTING	￿ PTZ speed set
		COMMAND		PAN/TILT STOP
		LENGTH		07
		CODE		FF	00	00	00
				00	00	00	00
SELECT : ▲▼, & [ENTER]		SELECT : ▲▼, CHANGE VALUE : + -

(1)CHANNEL : Select channel

(2)MODEL : Select camera model (protocol type) per each channel

(3)PTZ ID : Select ID

(4)BAUDRATE : Select data transmission speed

(5)CMD DELAY : Select command delay time

32