Philips VCR 462 warranty Go-To Feature, To remove the Goto display, press the GO-TO button again

Go-To Feature 53

Follow the steps below to program the VCR to go to a place on a tape with a specified tape counter location number.

•Make sure the VCR is in VCR position. (The VCR light will appear on the display panel. If it does not, press the VCR/TV button once.)

1

Press the VCR button.

2

When tape playback is stopped, press the GO-TO button

to bring up the GOTO display.

NOW	1:	00 : 00
GOTO	–:	– – : – –

3

Within 10 seconds, use the Number buttons to enter the desired tape counter location number. For example, to go to tape counter location number 1:20:00, press Number buttons 1, 20, 00.

NOTE: If the desired tape counter location number has a minus (–) before it, enter the minus by pressing the CHANNEL Down button. Press the CHANNEL Up button to remove the minus.

NOW	1: 00 : 00
GOTO	1: 20 : 00

1

CBL/DSS VCR TV

EJECT POWER MUTE

	VOL	F.ADV	CHANNEL
		PAUSE/STILL
		PLAY
	REW		FF
4	VCR PLUS+		LIGHT
	/ENTER	STOP
	EXIT/STATUS MENU		CLEAR
	1	2	3	3
	4	5	6
	7	8	9	2
	100	0	GO-TO
	REC/OTR	INDEX	MEMORY
		...
		...
		VAR. SLOW	TRACKING SKIP

SPEED VCR/TV SLOW SEARCH

4

Within 10 seconds, press the PLAY, STOP, POWER, or REC(ord)/OTR button. The VCR will fast forward or rewind the tape to the selected tape counter location. The tape counter will appear on-screen as the VCR rewinds or fast forwards the tape. Then, depending on which button you pressed, the VCR will either begin tape playback, stop the tape, turn itself off, or start recording the current channel.

Button pressed	VCR action
PLAY	Begin tape playback
STOP	Stop the tape
POWER	Turn off VCR
REC(ord)/OTR	Begin recording current channel

REMOTE LOCATOR

Helpful Hints

•To remove the GOTO display, press the GO-TO button again.

•The tape counter location number you enter at step 3 must be valid.

•To stop the tape during rewinding or fast forwarding (before the tape reaches the requested tape counter location number), press the STOP button.