Philips VCR 462 warranty Press the Number 1 button to select YES, Change the VCR Channels

46 Setting the Controller to Operate a DSS Receiver (cont’d)

6

Press the MENU button.

SELECT OUTPUT CH

OF YOUR DSS RECEIVER

0-	CBL/DSS	VCR	TV
TO END PUSH EXIT	EJECT	POWER	MUTE

7

A zero will appear in the SELECT OUTPUT CH menu. Press one Number button (3 or 4) to complete the out- put channel of your DSS Receiver (channel 03 or 04).

•Press 0 if you connected the VIDEO/AUDIO OUT Jacks of the DSS Receiver to the VCR’s VIDEO/AUDIO IN Jacks. A/V will appear on-screen as the output channel. A/V CONNECT A/V REAR ONLY will appear.

•If you make a mistake, press the CLEAR button, then enter the correct output channel.

SELECT OUTPUT CH

OF YOUR DSS RECEIVER

03

TO CONTINUE PUSH MENU

TO CORRECT PUSH CLEAR

TO END PUSH EXIT

8

Press the MENU button.

9

A four will appear in the menu. Use the Number buttons to enter the second digit of the two-digit code for your DSS Receiver. (See the list on page 44.)

SELECT CODE NUMBER OF YOUR DSS RECEIVER

42

TO TEST PUSH MENU

DID DSS RECEIVER

CHANGE TO CHANNEL 205?

1 YES 2 NO

TO END PUSH EXIT

10

Press the MENU button. Wait for the DSS Receiver to change to channel 205. When it does, go to step 11.

•If the DSS Receiver does not change to channel 205, press the Number 2 button to select NO. Repeat steps 9 - 10. If the DSS Receiver doesn’t change to channel 205, the Controller will not operate your DSS Receiver. Press the EXIT/STATUS button.

11

Press the Number 1 button to select YES.

“DSS RECEIVER CONTROL IS ON” will appear for five seconds. The screen will return to the program you were watching.

	VOL	F.ADV	CHANNEL
		PAUSE/STILL
		PLAY
	REW		FF
	VCR PLUS+		LIGHT	6
	/ENTER
		STOP
11 EXIT/STATUS MENU			CLEAR
9	1	2	3	8
	7	8	9	10
7	4	5	6
	100	0	GO-TO
	REC/OTR	INDEX	MEMORY
		...
		...
		VAR. SLOW	TRACKING SKIP
	SPEED VCR/TV SLOW		SEARCH

REMOTE LOCATOR

Helpful Hints

•If your DSS Receiver does not respond to the code in steps 9 - 10, the Controller will not change chan- nels at the DSS Receiver during a timer recording. In this case, you must select the channel to be recorded at the DSS Receiver before a timer recording begins. Leave the DSS Receiver on for the timer recording. Details are on page eight.

•If more than one code is listed for your brand of DSS Receiver, try all of the codes at steps 9-10 before you determine the Controller will not

change the VCR Channels.