Philips VCR 462 warranty Examine the lists on, 2page

	Setting Up the VCR Plus+ Programming System (cont’d) 39
2	Examine the lists on
	2page 38.

Now, compare the channel numbers you have written into the VCR PLUS+ CH. and CABLE/TV CH. columns. You’ll notice that some stations have VCR Plus+ and Cable/TV channel numbers that are the same, and other stations have channel numbers that do not match. Where the channel numbers DO NOT match, you must tell the VCR the VCR Plus+ and Cable/TV channel numbers according to the following steps.

3

Press the VCR button, then press the MENU button.

TO SELECT PUSH NO. SHOWN

1PROGRAM

2VCR SET UP

3TUNER SET UP

4INPUT SELECT

5SET CLOCK

6SET REMOTE LOCATOR

TO END PUSH EXIT

4

Press the Number 2 button to select VCR SET UP.

TO SELECT PUSH NO. SHOWN

1 SET REPEAT PLAY (OFF)

2 ON SCREEN MODE

3LANGUAGE

4SET VCR PLUS+ CH

5SET CABLE BOX

6SET DSS RECEIVER

7AUDIO OUT

8 VIDEO STABILIZER (OFF) TO END PUSH EXIT

3	CBL/DSS	VCR	TV
	EJECT	POWER	MUTE
	VOL	F.ADV	CHANNEL
			6
	PAUSE/STILL
		PLAY
	REW		FF
	VCR PLUS+		LIGHT
	/ENTER
7		STOP
	EXIT/STATUS MENU		CLEAR
4	1	2	3
	4	5	6
5	7	8	9
	100	0	GO-TO

5

Press the Number 4 button to select SET VCR PLUS+ CH.

6

Look at the columns you filled in on page 38. For stations whose VCR Plus+ and Cable/TV channels are not the same, use the CHANNEL Up/Down buttons to place the arrow beside the VCR PLUS+ channel. Then, press two Number buttons to enter the CABLE/TV channel. Entries must be made within one minute. If you enter the CABLE/TV channel incorrectly, you may enter it again.

Do this until you have entered all the channels on your list.

VCR PLUS+ CROSS REF. MAP

VCR PLUS+ CABLE/TV

9898

9999

01	– – – – –> 33
02	02

0303

TO SELECT CH PUSH CH UP/ DOWN, THEN ENTER CH. NO. TO END PUSH EXIT

7

Press the EXIT/STATUS button to exit.

REC/OTR	INDEX	MEMORY
	...
	...
	VAR. SLOW	TRACKING SKIP
SPEED VCR/TV SLOW		SEARCH

REMOTE LOCATOR

Helpful Hints

•To check the VCR PLUS+ and CABLE/TV channel listings, follow steps 3 - 5 above. A list of VCR PLUS+ and CABLE/TV channel num- bers will appear on-screen. To move through the list, press the CHAN- NEL Up/Down buttons. Make sure these numbers match your lists on page 38. Press the EXIT/STATUS button to exit.

•When you receive the VCR from the factory, all the VCR Plus+ channel numbers and Cable/TV channel numbers are the same in the cross reference map.