Philips TH-37PR10U operating instructions Color System / Panasonic Auto, Pulldown / Video NR

SET UP

SET UP for Input Signals

COLOR SYSTEM / Panasonic AUTO

Select SIGNAL from the “SET UP” menu during VIDEO (S VIDEO) input signal mode.(“SIGNAL [VIDEO]” menu is displayed.)

Press to select the “COLOR SYSTEM” or “Panasonic

AUTO”.

Press to select each function.

If the image becomes unstable:

With the system set on Auto, under conditions of low level or noisy input signals the image may in rare cases become unstable. Should this occur, set the system to match the format of the input signal.

SET UP	1/2
SIGNAL
COMPONENT/RGB-IN SELECT
INPUT LABEL	RGB
	PC
POWER SAVE	OFF
STANDBY SAVE	OFF
POWER MANAGEMENT	OFF
AUTO POWER OFF	OFF
OSD LANGUAGE	ENGLISH (US)

Press ACTION () button

SIGNAL	[ VIDEO ]
3D Y/C FILTER (NTSC)	ON
COLOR SYSTEM	AUTO
3 : 2 PULLDOWN	OFF
Panasonic AUTO (4 : 3)	NORMAL
VIDEO NR	OFF

Mode			Function
COLOR SYSTEM	Set the color system to match the input signal. When selecting “AUTO”, the color system is automatically
	selected from NTSC/PAL/SECAM, however, M.NTSC signal is not displayed properly depending on
	the attached terminal board. To display M.NTSC signal, select “M.NTSC” in COLOR SYSTEM.
	AUTO	PAL	SECAM	M.NTSC	NTSC
Panasonic AUTO	Set to “NORMAL” to view 4:3 images in an unchanged format when Panasonic AUTO is
(4 : 3 )	selected. If you would like to view 4:3 images in Just format, set to “JUST”.

Note:

Panasonic AUTO does not function when BNC Dual Video Terminal Board (TY-FB9BD) is used.

3:2 PULLDOWN / VIDEO NR

3:2 PULLDOWN: When ON, the display attempts to reproduce a more natural interpretation of sources such as movie

pictures, which are recorded at 24 frames per second.1/2 If the picture is not stable, turn the setting to OFF.

Notes:
	SIGNAL
When ON, this setting only affects the following signal input:	COMPONENT/RGB-IN SELECT
			RGB
• NTSC / PAL signal input during “VIDEO (S VIDEO)” input signal.
	INPUT LABEL		PC
• 525i(480i) 625i(575i), 1125(1080)/60i signal input during “COMPONENT” input signal.
	POWER SAVE		OFF
	STANDBY SAVE		OFF
VIDEO NR: Automatically reduces unwanted picture noise.	POWER MANAGEMENT		OFF
	AUTO POWER OFF		OFF
Note:
	OSD LANGUAGE	ENGLISH (US)

VIDEO NR cannot be adjusted while a PC signal is being applied.					Press ACTION (				) button
1	Press to select 3:2
		SIGNAL		[ VIDEO ]		SIGNAL			[ RGB ]
	PULLDOWN or VIDEO NR.
		3D Y/C FILTER (NTSC)		ON		SYNC			AUTO
	Press to set ON/OFF.
		COLOR SYSTEM		AUTO		3 : 2 PULLDOWN			OFF
		3 : 2 PULLDOWN		OFF
						VIDEO NR			OFF
		Panasonic AUTO (4 : 3)		NORMAL		H-FREQ.	33.8	kHz
		VIDEO NR		OFF
						V-FREQ.	60.0	Hz
		SIGNAL	[ COMPONENT ]			SIGNAL			[ Digital ]
		3 : 2 PULLDOWN		OFF		3 : 2 PULLDOWN			OFF
2		VIDEO NR		OFF		VIDEO NR			OFF
	Press to exit from adjust mode.
						V-FREQ.	60.0	Hz
						H-FREQ.	33.8	kHz

33