Philips DVDR75 owner manual Connecting to a TV Only TV has Component Video In Jacks

12 Hookups (cont’d)

Connecting to a TV Only

TV has Component Video In Jacks

Back of TV

(example only)

4

RIGHT	PR
AUDIO IN	CR
LEFT	PB
AUDIO IN	CB
	Y

5

ANTENNA	IN		OUT
	EXT 2	EXT 1
	VIDEO	AUDIO COMPONENT	VIDEO AUDIO	COMPONENT
	(CVBS)	VIDEO	(CVBS)	VIDEO

		Y
S-VIDEO		S-VIDEO
(Y/C)	L	(Y/C)
		PB
	AUDIO	AUDIO
	R	PR

TV

3

1

Y

PB

PR

DIGITAL

AUDIO OUT

2

Antenna or

Cable TV Signal

1 Connect your Antenna or Cable TV signal to the ANTENNA jack on the rear of the DVD Recorder.

2 Connect the Recorder’s OUT COMPONENT VIDEO (Y PB PR) jacks to the TV’s COMPONENT VIDEO IN jacks. Use the supplied three-strand component video cable, which has red, blue, and green markings. Match the cable colors to the jack colors.

3 Connect the Recorder’s white/red OUT AUDIO L/R (left/right) jacks to the TV’s left/right AUDIO IN jacks. Use a supplied two-strand audio cable, which has red and white markings. Match cable colors to jack colors.

4 Connect the supplied RF coaxial cable to the Recorder’s TV jack and to the Antenna In jack on your TV. Your TV’s Antenna In jack may be labelled RF In,Antenna In, or 75 ohm. Check your TV’s manual for details.

5 Connect the supplied power cord to the MAINS (AC Power) jack on the rear of the DVD Recorder.

Connect the power cords of the Recorder and the TV to a power outlet.

6 Press STANDBY-ON y on the front of the Recorder to turn it on. If “IS TV ON? CO3” appears on the display panel, you need to turn on your TV and set it to the correct Component Video In channel. (See next step.) This is part of the Initial Setup of the Recorder. You cannot see the Initial Setup screens until you turn on the TV and have it on the correct Component Video In channel.

7 Turn on the TV power. Set the TV to the Component Video In chan- nel. It is not channel 3 or 4 when you use Component Video. See your TV owner’s manual for details. Your TV remote may have a button or switch that selects the Component Video In channel. Or, go to your lowest TV channel and change channels down until you see the DVD background picture or Initial Setup screen on the TV. The Initial Setup screen will appear the first time you turn on the Recorder. Go to page 18 to continue.

Helpful Hints

•If your TV has Progressive Scan, connect the Recorder’s

OUT COMPONENT VIDEO (Y PB PR) jacks to the TV’s Progressive Scan In jacks instead. Progressive Scan pro- duces a clearer picture by dou- bling the number of visible pic- ture lines per field, providing a jitter-free, sharp, quiet picture. Check your TV manual for details.

Set the Recorder’s Video output to Progressive Scan. See page 60.

•On the TV, the Component Video In jacks may be labeled YUV or Pr/Cr Pb/Cb Y and may be green, blue, and red.