Philips DVDR75 owner manual Diagnostic Test

Page 68

68 Diagnostic Test

If you are still having trouble with the Recorder after checking Helpful Hints and other information in this manual, you may perform a Diagnostic Test on the Recorder. Follow the steps below.

1 Disconnect the power cord from the Recorder’s MAINS (AC Power) jack on the rear of the Recorder.

2 Press and hold the Play : button on the front of the Recorder while you reconnect the power cord to the Recorder. “BUSY” will appear on the display panel, along with a counter number. Release Play :. The counter will reach zero (0) when the test is finished.

3 Momentarily,“FAIL” or “PASS” will appear on the display panel.

If “FAIL” appears, your Recorder needs repair. Contact the Philips Customer Care Center for the Authorized Service Center nearest you.

If “PASS” appears, the Recorder apparently has no failure.The problem may be incorrect inter- pretation of the operating instructions, a wrong Disc in use, or incorrect connections. Contact the Philips Customer Care Center for further assistance in solving the problem.

4 If there is no failure, disconnect the power cord again, then reconnect it to the Recorder and an AC power outlet.The DVD Recorder will be ready for regular use.

Image 68

Contents DVDR75 Dear Philips product owner Remember, to get the most from your Philips prodCard within 10 days. So please mail It to us right now For Customer UseContents Safety Information Example of Antenna Grounding per National Electrical Code Safety Information cont’dCause the product and cart combination to over- turn Introduction Playable Discs Discs for Recording and PlayingDiscs Unsuitable for Recording or Playing Discs for Playing OnlyGeneral Information Hookups Determining the best possible connectionBefore you begin RememberConnecting to a TV Only TV has only an Antenna In jack Hookups cont’dConnecting to a TV and a Cable Box or Satellite Receiver Connecting to a TV Only TV has Component Video In Jacks Connecting to a TV Only TV has an S-Video In Jack Connecting to a TV Only TV has a yellow Cvbs Video In jack Turn on the TV power. Set the TV to the correct Audio/VideoSet Analog output accordingly. See Cable TV Signal DV S-VIDEO Video Audio Left Right Initial Setup Instructions continue on the nextPress STANDBYy to turn on the Recorder To choose the language you prefer, then press OKChoose the preferred TV Shape, then press OK Initial Setup cont’dFrom previous Quick Disc Playback To stop play at any time, press Stop CQuick Recording Remote Control Remote Control cont’d Front Panel Rear Panel Press System MENU. The Installation menu will reappear TV Channel ProgrammingMenu screen, then press to enter the Installation menu VCR Plus+ ChannelsYour time zone While storing the settingPress CH-9to choose Daylight Saving. Press or to Time/Date Manual 11Press System Menu repeatedly to remove all menusMenu Bars Menu BarOn-screen Symbols, Status Box On-screen SymbolsStatus Box Disc status iconsTitle Settings Menu Index Picture ScreenTitles Disc BarTimer Information box Current time no timer recordings are scheduledInformation Boxes Tuner Information boxTitle/Disc Menus, Chapter/Track Selection Title/Disc menusChapter/Track Selection Press Disc Menu during Disc playAudio Language SubtitlesZoom, Camera Angle ZoomCamera Angle During play, press System Menu so Menu Bar 1 appearsPress System Menu during play so Menu Bar 1 appears Still Picture/Frame-by-frame PlaybackSound Forward and Reverse Searching Slow Motion, SearchingSlow Motion Scan Time Search, ScanTime Search Repeat A-B Repeat, Repeat A-BRepeat One-Touch Recording Timer Recording When the Start time is correct, pressPress Timer on the remote control CH+8 to select VCR Plus+ system, then pressPress the Number buttons to enter the PlusCode number From your TV guide, then press OK. If you make a mistakeErasing Timer Recordings Press OK to erase the timer recording. Timer Cleared willTimer button.The Timer List will reappear Press Timer repeatedly to remove the menusError Messages Record One Channel/Watch Another Title Settings Menu Play full titleErase this title Press to return to the Index Picture Screen if necessaryAppend recording Chapter MarkersRecord Settings Editing Disc Information Screen Editing To select the next ChapterThis option is not always available Press FSS to remove the Favorite Scene Selection menuFinalize Disc Playback Control Press System Menu to remove the menusAccess Control Change CodeTwice.This will set your code for the first time Press CH-9repeatedly to select Change code, then pressChild Lock Press again, then press the Number buttons to enterYour four-digit code. See Child lock will be highlighted. PressAccess Control cont’d Locking or Unlocking Specific DiscsScreen. Child Lock should be Locked. See 1Insert a DiscParental Level Will stop. Enter the four-digit code to play the DiscYour four-digit code. Child lock will be highlighted Access Control contdChange Country DVD Recorder Features Menu Picture Settings Recorded in the regular formatDigital Output Digital output will be selected. PressAnalog Output Language Settings SAPRemote Control Used Night Mode, Remote Control UsedNight Mode Glossary Helpful Hints Helpful Hints contd Diagnostic Test Specifications Disc Formats SupportedLimited Warranty DVD RecorderInformation Index IB8451E001 3139 246 1336