Philips MCP9360I/22 manual Optional setup, Configure tuners,TV signal and Guide, Analogue setup

Optional setup

In the optional setup procedure you can customize your Media Center.The setup wizard enables you to:

–configure tuners,TV signal, and TV program guide information;

–select and adjust Media Center display settings;

–setup of speakers;

–control of your set-top box.

Configure tuners,TV signal and Guide

This option enables you to configure your connections for TV and radio signals.

1Confirm your region.

2Select the TV signal.

3Make your selection for a set-top box:

•Cable. Continue with ´Analogue setup´.

•Antenna:

-Analogue. Continue with ´Analogue setup´.

-Digital. Continue with ´Digital setup´.

Analogue setup

1Select the type of TV signal (Europe - PAL/SECAM).

2Make your selection for a set-top box: a If you have a set-top box:

•Make sure that your set-top box and IR-receiver cable are connected properly (see ´Installation of your Philips Media Center – Connecting video equipment (e.g. a set-top box)´).

•Select a TV signal

b If you do not have a set-top box:

• Follow the on-screen instructions.

3Setup Electronic Television Program Guide.

•Read the Guide Terms of Service and accept.

•Enter your postal code.

•Select your TV signal provider.

>Your Media Center uses the internet connection to download all TV station information from your TV signal provider. Every available station is stored as a separate preset number.

Digital setup

1Select the type of TV signal: ´Digital terrestrial (DVB-T)´.

2Make your selection for a set-top box: Select ´No´.

3Read the Guide Privacy and accept.

4Setup Electronic Television Program Guide.

•Read the Guide Terms of Service and accept.

•Enter your postal code.

•Downlaod the provider information

•Select your TV signal provider. Select ´Digital terrestrial – all channels´.

•Download the TV Program Guide Information.

Optimize how the Media Center looks on your display

This option enables you to adjust display settings.

1Select your display type.

2Select the connection type of your display.

Note: If you are using the SCART output (21) of the Media Center, select Component (YpbPr).

3Adjust display settings to your personal preferences in Display Calibration.

Note: If you select a wrong display setting the screen may turn black. Please wait for about 15 seconds, then the on-screen infor- mation will be be visible again.

21