RU 098/00- page 4
English
SBC RU 098
INTRODUCTION
Congratulations on your purchase of the Philips SBC RU 098 remote control. The SBC RU 098 is the simplest remote control in the Philips universal range. It is
SBC RU 098 contains just four functions for maximum ease of use; Power, Program
FUNCTIONS OVERVIEW (see diagram on page 3)
1P + Next programme
2 P - Previous programme
3 
+ TV Volume louder
4 
- TV volume softer
5 c Mute
6 y Power
7 Indicator LED
BATTERIES
Insert the batteries as indicated in the battery compartment (rear of remote). Only use batteries of type R03, UM4 or AAA. Replace the batteries when required, or at least once a year.
Dispose of used batteries properly.
SETTING UP BY CODE ENTRY
Before you set up the SBC RU 098 to operate your TV, look up the first code for your TV in the brands list on page 26.
1.Press and hold c 5 and y 6 at the same time for 3 seconds.
–The indicator LED lights up.
2.Enter the
–The indicator LED blinks twice to indicate successful
–Press buttons on the SBC RU 098 to check that the code works on your TV. If it does, write down this code inside the SBC RU 098's battery lid.
–If the TV does not respond correctly, try the next code from the code list until the TV responds correctly.
–If none of the listed codes work, go to Chapter SETTING UP BY AUTOSEARCH
SETTING UP BY AUTOSEARCH
Before you start, make sure your TV is ready to receive
1.Press and hold c 5 and y 6 at the same time for 3 seconds.
–The indicator LED lights up.
2.Press y 6 to start the search.
–Every time the LED lights, another code is tested. When the right code for your TV is found, the TV switches off. Immediately proceed with step 3.
4