Philips SBC RU631/87 manual Advanced Tips and Tricks, Changing the device keys, Vcr Sat Cable

XP SBC RU 631/87 2002 15-10-2001 12:45 Pagina 6

English

Instructions for use

47 Press key 4 and count the number of flashes for the forth digit.

8 Note the code.

ADVANCED TIPS AND TRICKS

A d v i c e

Carefully read the complete procedure before starting!

Changing the device keys

With the mode selector it is possible to select 4 categories of devices you want to operate. Each category (TV, VCR, SAT and DVD) is meant to operate a specific group of equipment:

TV	VCR	SAT
tv	vcr	sat
		cable

VCR

TV SAT

1 6

Once you have programmed the functions of a device in one of the categories, it is not possible to program another device in the same category. There is, however, a solution in case you want to program two devices in the same category

(2 TV’s, VCR’s, etc.). The following example explains how.

EXAMPLE:

The SAT mode on this remote control is factory preset to control many Philips satellite receivers. You can change the SAT mode (or any mode) to operate another type of device. The following example shows you how to use the SAT mode to operate a second TV:

1 Press the mode selector key to select SAT and make sure the second TV is switched on.

2 Press and hold keys 1 and 6 simultaneously -for about 3 seconds- until the green LED lights up.

9	9	2	3 On the keypad, press keys 9, 9 and 2.
			4 Press the mode selector key to select TV mode.
	VCR
	TV	SAT

5 Press key 1.

1– The LED flashes twice to indicate successful set up. That’s it!

Don’t forget to set up the SBC RU631 to operate this second TV. See the section Set-up for use.

6