Philips DVDR80 manual Continue set

Setup Home

Press Aor Bto select. Then press OK to confirm.

Setup
Choose item to set up :
Language	English
Country	United Kingdom
Postal code	XXXXX
External receiver 1	None
External receiver 2	None
External receiver 3	None

Continue set ENGLISH

1Check the settings shown on the screen.

If the settings are not correct, choose the line in which you want to change the settings and confirm with OK .

2Press the green function button to leave the screen.

3If you want to view a demonstration of the GUIDE Plus+® system select 'View Demo' with P- B and confirm with OK .

If you start the demo, programmed recordings can be deleted.

If you do not want to see a precentation of the GUIDE Plus+® system, end using GUIDE/TV .

4This completes the set-up process for the GUIDE Plus+® system.

Leave the DVD recorder switched off with the STANDBY m button (preferrably during the night) to load the GUIDE Plus+® data.

The information will be available in the next 24 hours.

What must I pay attention to when installing an external receiver for the first time?

•) The receiver must be switched on.

•) If you can switch between 'TV' and 'Radio' on the receiver, select 'TV'.

•) Select the TV channel that transmits the GUIDE Plus+® data on the receiver. You will find the corresponding TV channel for your country in the table in section 'General Information' in chapter 'The GUIDE Plus+ System'.

•) On the DVD recorder, select the programme number of the input socket to which the external receiver is connected:

'￿￿￿￿'	Scart socket at the back of the DVD recorder EXT 2 AUX-I/O
'￿￿￿￿'	S-Video/Video front sockets S-VIDEO / VIDEO
'￿￿￿￿'	Scart socket at the back of the DVD recorder EXT 1 TO TV-I/O
•) If the external receiver is only connected to the aerial socket, you must
select the programme number on the DVD recorder under which the
external receiver is stored.
•) The DVD recorder must be switched on.
•) If GUIDE Plus+® data were loaded, switch the DVD-Recorder off with the
STANDBY m button for approx.10 minutes. During this time, the data will
be stored in a memory to prevent them from being erased in case of
malfunction (power failure).
You must observe this information only when installing the receiver for the
first time. At this point, there is no GUIDE Plus+® data available yet in order		Tip
to automatically detect the TV channel that delivers the GUIDE Plus+® data.

The GUIDE Plus+® System 43