Satellite Receiver with a recorder
| Monitor | AV 1 | AV 2 |
| in | ||
| out | in | |
| VIDEO | Y | CABLE |
|
|
| |
| L / Mono |
|
|
5 | AUDIO | Pb | |
R |
| 3 | |
75 |
| Pr |
|
&Connect the RF Antenna or Cable TV cable 1 to the RF IN socket of your recorder.
éConnect another RF cable 2 from the output of your recorder to the TV’s 75 ø x jack.
“Connect the satellite antenna cable 3 to the satellite receiver’s SATELLITE IN jack.
OUT |
| SAT |
IN |
| IN |
| OUT | |
OUT |
|
|
IN | 4 | ≈ |
|
‘Connect the AV cables 4 to the satellite receiver’s AV OUT jacks and to the VCR’s AV IN jacks.
( Connect the recorder’s AV OUT jacks 5 to the TV’s |
REC
SAT
AV2 IN jacks. |
DVD player or other accessory digital source equipment
Monitor | AV 1 | AV 2 |
out | in | in |
VIDEO |
|
|
| Y |
|
L |
|
|
AUDIO | Pb | |
|
| |
R | Pr |
|
|
|
Equipment with AV connectors only
&Connect the video cables to the equipment’s AV OUT jacks and to the TV’s AV1 or AV2 IN jacks.
éConnect the audio cables to the equipment’s AUDIO L and R jacks and to the L AUDIO and R AUDIO AV1 or AV2 jacks on the TV. (According to where you connected the video cables, to AV1 or AV2.)
Equipment with an S-VIDEO connector
&Connect an S-video cable the AV2 S-VIDEO input.
Note: When using the
éConnect the audio cables to the equipment’s AUDIO L and R jacks and to the L AUDIO and R AUDIO AV2 jacks on the TV.
With Component Video Output Connectors
&Connect the cables of your YPbPr equipment 1 to the YPbPr input AV1 IN sockets on the TV.
Note:The YPbPr sockets on the TV are compatible with 480i (interlaced, 1 Fh) output signals only, not 480p (progressive scan, 2 Fh).
éFor reproduction of CVI (Component Video Input) and in order to have correct picture reproduction, also connect a video cable to video of AV1 2.
Note:This connection is used for AV1 (CVBS).
“Connect the Audio left and right (only for stereo devices) cables 2 to the AUDIO L and R input of AV1.
Remark: Equipment may also be connected to the AV IN jacks (SIDE) at the right side of the TV.
Warning: Never connect a signal to the
Equipment with Progressive scan output (480p or 1080i 2 Fh)
Connect the equipment to the AV4 IN jacks on the TV.
See AV3 or AV4 Digital HD input, next page.
Note:The labels for the component video sockets may differ depending on the DVD player. Although the abbreviations may vary, the letters B and R stand for the blue and red component signals, respectively, and Y indicates the luminance signal. Refer to the DVD player’s instructions for use for definitions and connection details.
15