Philips CCA134AT owner manual Glossary

Page 63

Glossary 63

AUDIO Jack: jack located on the front of the TV/VCR which is used to record audio from another source.

Automatic Channel Setup: process in which the TV/VCR scans all available channels and places the ones you receive in its memory. Then, when you push the CHANNEL o/p buttons, you only scan through channels you receive.

Bands: settings that allow you to tune channels.

•Antenna – VHF (very high frequency; channels 2-13) and UHF (ultra high frequency; channels 14-69).

•Cable – all standard channels can be received without a Cable Box.

Brightness: adjusting increases or decreases the brightness of the color on the screen.

Color: adjusting pales or brightens the TV/VCR color.

Dubbing: copying a tape using a VCR.

HQ: high quality; a feature in the TV/VCR circuitry which pro- vides enhanced picture detail.

Line Input: The channel to which you set your TV/VCR during dubbing. The line input channel is always channel 00 (A/V IN).

Mode: a TV/VCR operation.

OTR: One-Touch Recording; a timed recording that starts immediately and records for 30 minutes to eight hours, whichev- er you specify.

Picture: adjusting increases or decreases the contrast of the pic- ture on the screen.

Sharpness: adjusting softens or clarifies the picture on the screen.

Tape Speeds: how fast the tape travels during playback or recording.

•SP (standard play) – fastest tape speed (recording time for a T120 tape is approximately two hours); best picture quality.

•LP (long play) – average tape speed; playback only.

•SLP (super long play) – slowest tape speed (recording time for a T120 tape is approximately six hours).

Tint: adjusting changes the tints of the picture on the TV/VCR from purple to green.

VIDEO Jack: jack located on the front of the TV/VCR which is used to record video from another source.

Image 63

Contents CCA134AT RA T I O Dear Philips Magnavox product ownerFor Customer Use Model No Serial NoFeatures Safety PrecautionsIntroduction Table of Contents Erasure Prevention Putting Batteries in the Remote ControlUsing the Remote Control TV/VCR MaintenanceRod Antenna Hook up your TV/VCR using one of the connections shownHooking Up the TV/VCR RF coaxial cable Not suppliedCable Plug Hooking Up the TV/VCR cont’dBent pin Crooked Pin Straight PinEspañol Select KL or Press Menu to Continue Turning On the TV/VCRPress the Menu button. The screen shown below will appear Select Language EnglishPress the Combi button, then press the Menu button PRIM. SetupVCR Program VCR Setup Caption Reminder Language SelectionPress B Automatic Channel SetupProgramming of the channel you added or deleted will appear Adding/Deleting ChannelsPress the PLAY/o button or the STOP/p button to select Repeat steps 3-4 to add or delete other channelsSetting the Clock Manual Clock SettingCable Box users must set the clock manually To Correct Press Clear To END Press Exit SET Manual Clock TimeMonth To Correct Press Clear To END Press Exit DateAutomatic PBS Channel Selection Setting the Clock cont’dNOW Searching Wait for the TV/VCR to findTime SET Auto Clock TimeManual PBS Channel Selection Auto Clock PBS CH Time Date NOW Searching To END Press Exit Use the Number buttons to select your PBS stationNOW Searching flashes on the TV/VCR screen Wait for the TV/VCR to find the timePrimary Setup Daylight-Savings TimeTime Daylight Savings Time PRIM. SETUP. Then, press the F.FWD/B button Time ZonePress the PLAY/ button or the STOP/ button to select Cable BOX Codes Setting the Remote to Operate a Cable Box/DBSSetting the Remote to Operate a Cable Box/DBS cont’d Front Panel Connect your antenna or cable here. Details are on page six AC Power CordRear Panel ANTenna JackRemote Control Buttons REWind/ Button VOLume m/n ButtonPAUSE/STILL Button Memory ButtonPress the REWind/ button or the F.FWD/B button to Adjusting the Picture ControlsAdjust the picture control. Refer to the chart on When you finish, press the STATUS/EXIT buttonSofter Adjusting the Picture Controls cont’dDecrease Increase More brilliantIf you select Status OFF On-Screen Status DisplaysIf you select Status ON, then select Counter only OFF If you select Status ON, then select Counter only onInsert a tape in the TV/VCR PlayingPower button to turn on the TV/VCR, if necessary RecordingPress the RECord/OTR button once to start recording Length Press OTR Cancel Press Clear OTROTR Different brands of equipment may operate differently Rerecording Tape DuplicationFollow the steps below to prevent accidental recording VCR Program VCR Setup CaptionVCR Setup ONE Time Play Repeat Play ON-SCREEN Mode Defeat RecordingTimer Recording DailySelect Program Number To END Press Exit Time OFF To Correct Press Clear To END Press Exit ONE Time Program Channel Time onTimer Recording cont’d Checking or Clearing Timer Recordings Setting Up the VCR Plus+ Programming System TV ChannelsStation VCR PLUS+ Cross REF. MAP VCR PLUS+ CABLE/TV Examine the lists onVCR PLUS+ Cross REF. MAP To Select CH Press then Enter CH NO. to END Press ExitYou have completed the steps on pages VCR PLUS+ ProgramTo SET Press VCR + To Correct Press Clear To END Press Exit Timer Recording With the VCR Plus+ Programming System cont’d Appear on the screen Real-Time Counter MemoryVCR Setup ONE Time Play VCR Program VCR SetupRepeat Play B Repeat PlayRepeat Flashing a will become a flashing BViewing a Still Picture Playback OptionsForward and Reverse Searching SP/LP/SLP Super High Speed Searching LP/SLPGround Blue BackgroundTo block ratings, follow the steps below SmartLockSmartLock cont’d Ratings are defined onExample Specific Sub-ratings After you enter the code, the Smartlock menu will appear To change the access code, follow these stepsTo check the SmartLock settings, follow these steps Blocked RatingsTV-Y7 TV-G Sleep Timer Timer during a recordingPress the Combi button, then press the SLEEP/WAKE UP button Timer Sleep Wake UP Timer Sleep Wake UP TV on ON-TIMEScreen Closed CaptionExample MenuClosed Caption cont’d Standard Closed CaptionsHalf-screen text Volume Bar Automatic Operation Features Smart Picture TV ResetPress the Mute button, then press the PAUSE/STILL button If another remote control beepsReminder Brightness Picture Color Tint Sharpness ReminderIndex Search Enter Index Number Tape in the TV/VCRSpecifications Glossary Helpful Hints Helpful Hints cont’d Limited Warranty Please contact Philips at French Speaking English SpeakingModel # Serial # Index Supplied Accessories