Philips PFL50X8M/08, PFL50X8T/12, PFL50X8T/60, PFL50X8K/12 Wired connection, WiFi integrated

You can connect this TV to your home network through a wired or wireless connection.

∙For a wired connection, see Connect your TV > Connect to a network and the Internet > Wired connection (Page 59).

∙For a wireless connection, see Connect your TV > Connect to a network and the Internet > Wi-Fi integrated (Page 59).

Wired connection

1.Switch on the router and switch on its DHCP setting.

2.Connect the router to the TV with an Ethernet cable.

3.Press , then select [Setup].

4.Select [Connect to network], then press OK.

5.Follow the onscreen instructions to install the network.

6.Wait for the TV to find the network connection.

7.If you are prompted, agree to the End User Licence Agreement.

WiFi integrated

This section is only applicable for WiFi- integrated TVs.

You can connect your TV to your home network wirelessly.

Note:

∙The wireless network operates in the same 2.4 GHz frequency spectrum as common household devices, such as Dect phones, microwave ovens or Bluetooth devices, which can cause WiFi interference. Move these devices away from the TV.

∙	For optimum WiFi performance, place
	the TV at a distance of less than 10 m	English
	from the wireless router. Avoid
	obstructions such as concrete walls
	between the router and the TV.
∙	Reception quality depends on the
	location of the wireless router and your
	local Internet service provider.
∙	To reduce network traffic, switch off
	unused network equipment in the
	home network.
∙	When playing video over your wireless
	home network, we recommend that
	you use an IEEE 802.11 N router. The
	connection speed may differ according
	to the operating environment of your
	wireless home network.

Start wireless setup

1. Switch on your wireless network router.

2. Press on the TV remote control.

3.Select [Setup] > [Connect to network], then press OK.

4.Follow the onscreen instructions.

WPS - Wi-Fi Protected Setup

1.If your router supports Wi-Fi Protected Setup (WPS), press the WPS button on the router.

2.After 2 minutes, select [WPS] on the TV, then press OK.

The TV connects to your network. This takes about 2 minutes.

Most new wireless routers have the WPS system and carry the WPS logo. The WPS system uses WPS security encryption and cannot be combined with devices on your network that use the WEP (Wired Equivalent Privacy) security encryption.

If you still need the WEP devices in your network, install with [Scan] > [Custom].

Scan for routers

If you have several routers in your network, you can select the network you need.

1.To select a specific network router, press [Scan] on the first page of the installation. The routers with WPS and the strongest signal are shown first in the list on screen.

2.Select the router you need, then press OK.

EN 59