Philips 26HFL5870D/10 user manual Automatically install the channels, Network Frequency

Page 22

6Automatically install the channels

This section describes how to install the TV channels automatically.

1 Enter the setup menu.

2 Press to select [AUTO INSTALL].

	AUTO INSTALL
DVB-C	>
DVB-T	>
ANALOG	>
START	>

3 Press to select one of the following:

•[DVB-C]: Installs DVB-C channels.

The [FULL SCAN] searches all frequency spectrum and takes approximately 2 hours. Filling in [MODULATION] type and [SYMBOL RATE] will speed up auto installation.[QUICK SCAN] takes a few minutes but it needs additional parameters such as [NID] and

[NETWORK FREQUENCY].

•[DVB-T]: Installs DVB-T channels.

•[ANALOG]: Installs analog channels.

•[START]: Starts the automatic installation of channels.

Note

•The complete installation takes a few minutes and up to 2 hours if DVB-C Full Scan is enabled. When complete, the first tuned channel appears on the TV.

22EN

Image 22

Contents Register your product and get support at Page Contents Koninklijke Philips Electronics N.V. All rights reserved To use according to scientific evidence available todayFatto in Székesfehérvár, il 02 Febbraio Hungary Safety Risk of electric shock or fireScreen care Disposal of your old product and batteriesPage Guest menu TV overviewSide controls » The guest menu is displayedAccess the guest menu with guest remote control Access the setup menu with PBS setup remote control Access the setup menu with guest remote controlSelect a language Navigate the setup menuSelect the country Set the clock Press to configure one of the followingSet the number of channels Set the number of channels for different kindsPage Configure the switch-on settings Switch on / OSDPreset the picture format Preset the switch-on channelPreset the switch-on volume Preset the switch-on power modeDisplay the channel banner Enable or disable the volume indicatorSet the channel display Select the preferred audio and subtitle languageConfigure the security settings Configure the picture settingsConfigure the sound settings Commercials are aired or when you switch channelsSelect the security level Enable or disable the TV controlsEnable or disable the remote control Security Keyboard LockEnter the setup menu Press to select Configuration Control Configure the control optionsAutomatic detection of Scart signal Or select no to enable the tuning of double digit channelsInsert RGB Select the energy saving optionEnergy Saving Automatically install the channels Network FrequencySelect the type of input Select the systemSelect a program Customize the TV channelsLabel a channel Select a ringChannels Mute a channelClone data USB connector of your TVUpgrade Cloning Press To select CloningPage To a remote control of one of those colors HealthcareConnect devices Back connectorsVGA Side connectors Use a Kensington lock Use a Conditional Access ModuleAccess CAM services Insert and activate a CAMProduct information Supported display resolutionsPower MultimediaNo access to PBS setup menu TroubleshootingTV power on/ off issues Picture issuesGuest RC does not work Communication issuesOther issues Contact usCAM IndexAudio/video out Auto Scart ESPG l i s h