3.5Manage cables
Route your mains cord, antenna cable and all other device cables through the cable holder
(1)at the back of the TV.
1
3.6Insert the remote control batteries
1.Slide the battery cover off the back of the remote control.
2.Insert the two suppplied batteries (Size AAA, Typpe LR03). Be sure the + and - ends of the batteries line up with the markings inside the case.
3.Slide the cover back into position.
DDNote
Remove the batteries if not using the remote control for an extended period of time.
3.7Switch on the TV
The first time you switch on the TV, check that the mains cord is properly connected.When readyy, then press POWER on the side of the TV.
DDNote
Certain TV models require you to press and hold POWER for up to two seconds.Your TV may take up to 15 seconds to start.
3.8First time setup
When you turn on the TV set for the first time, a menu is displayed on screen.This menu prompts you to select the Country and Language for the menus:
If the menu is not displayed, press the MENU key to display the menu.
1.Press Î or ï to select your language, and press OK to confirm your choice.
2.Press Î or ï to select your country, and press OK to confirm your choice.
The search starts automatically. All available TV programmes and radio stations are stored.This operation takes a few minutes. The display shows the progress of the search and the number of programs found. At the end of the search, the menu disapppears.
DDNote
If no programme is found, consult the possible solutions see section 9 troubleshooting.
If the transmitter or cable network sends the automatic sort signal, the programs will be numbered correctly. In this case, the installation is complete.
3.If this is not the case, use the Channel setting menu to number the programs correctly.