Philips FTR 9965/12 Assembling and mounting the wall mount unit, Mounting the plasma display

Assembling and mounting the wall mount unit

&Securely fasten the upper and lower wall-side fittings to the middle wall-side fitting with the four supplied M4 screws.

éFasten the unit with commercial anchors or the four screws. Be sure that the anchors or screws are fastened at a position where there is a post.

Note: Use anchors and screws to suit the various wall types. The enclosed template can be used for general positioning only.

Make sure that the wall mount unit is being fixed securely enough so that it meets safety standards.

Mounting the plasma display

&Mount the display (to which the display fittings have already been attached) to the wall mounting unit.

éFit the upper hooks of the display fittings into the grooves of the (upper) wall fittings and adjust for level positioning.

Note: It is recommended that the power cable and various signal cables be plugged into the display before mounting the display. After mounting the display, plugging in the cables may be difficult.

If the display is tilted to the left or right, the display fitting is not properly placed on the wall mounting unit. Slide in the direction of the lower side and adjust for level positioning.

“Anchor the plasma display.

Align the thumb screw, which is located at the bottom of the display fitting, with the hole of the (lower) wall-side fitting and tighten to anchor.

Fasten securely until the screw ceases to turn.

To remove the display, loosen the thumb screws until they come out of the hole.

Pull the bottom portion of the display towards you and lift upward to release the display.

CAUTION

Firmly support the display when mounting it.

Failure to do so may result in the plasma display falling and causing injury.

Unpacking and wall mounting instructions 3