The batteries supplied do not contain the heavy metals mercury and cadmium. Nevertheless in many countries batteries may not be disposed of with your household waste. Please check on how to dispose of batteries according to local regulations.
“ Make sure that your receiver box and/or PC are switched on and that your PC is in the correct display mode (see p. 11).
In case of a Multimedia computer, connect the audio cable to the audio outputs of your computer and to the AUDIO VGA IN R (right) and L (left) inputs of the receiver box.
é
Directly to the plasma display
& Connect one end of a VGA cable supplied to the video card of the computer and the other end to the VGA (or to RGB Digital DVI in case of a computer with a digital RGB output) connector at the rear side of the monitor. Fix the connectors firmly with the screws on the plug.
See Table of Signals Supported, p. 11.
é In case of a Multimedia computer, connect the audio cable to the audio outputs of your computer and to the audio inputs of an additional audio receiver.
To an electronic receiver box
See the handbook of the receiver box.
& Connect one end of a VGA cable to the video card of the computer and the other end to the VGA IN connector at the rear side of the receiver box. Fix the connectors firmly with the screws on the plug.
Click the lids tightly until the clamps click. Use the bands to secure the ferrite cores.
“
‘
Connect your computer
Note: When you connect a computer to this monitor, attach the supplied ferrite cores. If you do not do this, this monitor will not comply with the mandatory CE or C- Tick standards.
& Set the (large) ferrite core on one end of the power cable (supplied).
é In case of a computer with a digital RGB output set the (small) ferrite cores on both ends of the DVI cable (not supplied).
Operation
&Insert the mains plug supplied into the mains inlet at the bottom of the monitor and in the wall socket. For safety, please, only use the supplied rim- earthed mains cord which has to be inserted in a grounded socket.
éRemote control: remove the cover of the battery compartment. Insert the 2 batteries supplied (Type LR6/AA-1.5V).
R6 / AA
‘Switch the plasma display on : Press the power button B at the
bottom side of the monitor.
A green indicator lights up and the screen comes on.
When the plasma display does not receive a supported vga signal or is not connected to a receiver box, the screen switches to standby and the red indicator lights up.
Warning:The POWER ON/OFF switch does not disconnect the plasma display completely from the mains.
Power On/Off
Mains inlet
Connect your computer + Operation 5
