Getting Connected Up | ● |
| |
VCR to TV Connection Using RF Cable |
|
1Disconnect the antenna or cable from the TV.
2Connect the antenna or cable to the ANT. IN terminal on the back of the VCR.
3Connect the VCR to the TV using the RF coaxial cable.
4Plug the AC power cords of the VCR and TV into the AC outlets.
Indoor antenna
Outdoor antenna |
|
|
Back of VCR |
| Back of TV |
|
| ANT. IN |
IN | OUT ANT.IN |
|
| R | VHF |
| AUDIO | |
| L |
|
| VIDEO | UHF |
| RF OUT |
|
Cable
RF coaxial cable
RF OUT
CAUTION
Do not plug the AC power cords until all connections are completed.
Note:
VR407/55 has single AUDIO IN/OUT jack.
To watch a picture from this VCR on the TV, select UHF E36 channel (video
channel of this VCR when shipped from the factory).
If you want to change video channel, see “Setting the Video Channel.” ( ✈P.5)
VCR to TV Connection Using AUDIO/VIDEO Cable
If your TV has audio/video connectors, complete the connection below to get better pictures and sounds when playing back a tape. To watch a picture from this VCR on the TV, select the AV mode on the TV.
Note;
Even if you are using this AV connection, you must also complete the RF connection above.
Back of TV
Back of VCR
VR407/55 |
|
| ANT.IN | Audio cable |
|
IN | OUT |
|
|
| |
|
| AUDIO |
|
|
|
|
| VIDEO |
|
|
|
To VIDEO/ |
|
| RF OUT |
|
|
|
|
| Video cable |
| |
AUDIO OUT |
| ANT.IN |
| Audio cable |
|
jacks | IN | R |
|
| |
| OUT |
|
|
| |
|
| AUDIO |
|
|
|
|
| L |
|
|
|
VR607/55 |
| VIDEO | RF OUT |
| To video and audio |
|
|
|
| Video cable | input jacks |
4