Philips VRB664AT Recording, Turn on the TV and set it to channel 3 or 4, whichever chan

Page 31

Read and follow the steps below to record a television program.

1

Turn on the TV and set it to channel 3 or 4, whichever chan-

Recording 31

1Turn on the TV.

2Insert a tape in the VCR.

nel to which the CH3/CH4 switch on the back of the VCR is set.

2

Insert a tape with its record tab intact in the VCR.

3

Press the VCR button.

4

POWER

4 VCR/TV

REC/OTR

7 REW

MENU

SPEED

PLAY

STOP

STATUS/EXIT

EJECT

MEMORY

PAUSE/STILL

F.FWD

CLEAR

5

8

9

If the VCR light appears on the display panel, go to step 5. If the

VCR light does not appear, press the VCR/TV button once.

5

Press the SPEED button until the desired tape speed appears briefly on the screen. (Details about tape speed are on page 36.)

6

Use the CH(annel) o/p button or the Number buttons to select the channel to be recorded.

7

Press the REC(ord)/OTR button once to start recording. The Record light will appear.

8

To pause the recording, press the PAUSE/STILL button once. The Record light will flash. To resume recording, press the REC(ord)/OTR button or press the PAUSE/STILL button again. The Record light will come on again.

9

To stop recording, press the STOP/p button.

	1	2	3		6
	1	2	3
	4	5	6	CH.
	4	5	6
	7	8	9
3	MUTE	0	ALT.CH	VOL.
				VOL.
	VCR	TV	CBL/DBS
			VCR PLUS+
	VAR.SLOW		/ENTER	SLOW
	TRACKING		F.ADV	X2 PLAY
	SMART	TIME	INDEX REC END	SKIP
	PICTURE	TIME	INDEX REC END	SKIP

SEARCH

Helpful Hints

•If you press the REC(ord)/OTR but- ton when there is not a tape in the VCR, NO CASSETTE will flash on the screen.

•If you press the REC(ord)/OTR but- ton while a tape without a record tab is in the VCR, the VCR will eject the tape and PROTECTED CAS- SETTE CANNOT RECORD will flash on the screen.

•Other recording options are on pages 32-43.

•You can change the tape speed during a recording, but some distor- tion will appear on the tape.

•The VCR will record in a preset vol- ume.

Image 31

Contents VRB664AT For Customer Use Dear Philips product ownerIntroduction FeaturesDeclaration of Conformity Table of Contents Removing the Plastic Cover from the Front Panel Putting Batteries in the Remote ControlUsing the Remote Control VCR maintenanceDisconnect the antenna or cable from your TV Hookups Without a Cable Box/Direct Broadcast SystemPlug in the TV and the VCR Hookups Without a Cable Box/Direct Broadcast System cont’dConnections Hookups With a Cable Box/Direct Broadcast SystemRecording/Viewing Any Channel Recording One Channel/Watching Another Hookups With a Cable Box/Direct Broadcast System cont’dHookups With a Stereo TV Press the Menu button. The display shown below will appear Turning on Your VCRPress the VCR button Press the Menu button Automatic Channel SetupAdding/Deleting Channels Automatic Channel Setup cont’dPress the STATUS/EXIT button once or twice to exit Reviewing Memorized ChannelsDo each step within 60 seconds of the previous step Manual Clock SettingInstructions continue on Enter a 0 before a single-digit number Setting the Clock cont’dPress the VCR button, then press the Menu button Automatic Clock SettingTime Zone Daylight-Savings Time Language Selection Setting the Remote to Operate a TV Cable BOX Codes Remote Control Buttons Remote Control Buttons cont’d Number Buttons REWind/ ButtonRECord/OTR Button Menu ButtonIf you select Status ON, then select Counter only OFF On-Screen Status DisplaysStatus Display example only If you select Status ON, then select Counter only onVCR Display Panel Front Panel Rear Panel VHS Quasi Play Back Sqpb PlayingTurn on the TV and set it to channel 3 or 4, whichever chan RecordingOTR CH12 One-Touch RecordingRecording One Channel/Watching Another Daily Timer RecordingTimer Recording cont’d Press the STATUS/EXIT button. Program WAS COM Timer Recording cont’dTape Speeds Checking or Cancelling Timer Recordings Channels Setting Up the VCR Plus+ Programming SystemSetting Up the VCR Plus+ Programming System cont’d Timer Recording with the VCR Plus+ Programming System See page 58 for more hints Set the clock. Details are on pages Auto DBS RecordLinkRF coaxial cable Rerecording Tape DuplicationPress the PLAY/o button or the STOP/p button to select Repeat PlayPress the F.FWD/B button so that on appears beside Automatic Operation Features Playing a Tape at Double Speed Special Effects PlaybackForward and Reverse Searching SP/LP/SLP Super High Speed Searching LP/SLPViewing a Slow Motion Picture Viewing a Still PictureDuring tape playback, press the PAUSE/STILL button. a Child Lock When Child Lock is activatedSmart Picture Press the VCR button Press the Time Search button Time SearchPress the VCR button Press the Index Search button ExampleSkip Search Record End SearchReal-Time Counter Memory Blue Background Understanding On-Screen Displays Multi-Channel Television Sound SystemMulti-Channel Television Sound System cont’d Please see additional notes on Hi-Fi Stereo Sound SystemHelpful Hints Helpful Hints cont’d Cable Box/DBS Output Channel 03 or GlossarySpecifications Video Cassette Recorder or Player Limited WarrantyPayment, if applicable Limited Warranty cont’dTo obtain a replacement product from Philips Payment AmountAutomatic IndexPage Page Page Supplied Accessories