Philips VRZ255 owner manual Before Using Your VCR

Page 5

Before Using Your VCR 5

Removing the Plastic Cover from the Front Panel

A thin, plastic cover may protect the front panel of your VCR.

Before using the VCR, lift a corner of the plastic, then peel it off.

Putting Batteries in the Remote Control

1

To open the battery compartment, push in the tab, then pull up the lid.

2

Place two AA batteries inside the battery compartment with their + and – ends aligned as indicated.

3

Close the battery compartment lid.

Using the Remote Control

Do not put objects between the remote control and the VCR.

Press the VCR button, then point the remote control at the VCR’s remote sensor, before pressing other VCR operation but- tons.

Press the TV button, then point the remote control at the TV, before pressing other TV operation buttons.

Press the CBL/DBS button, then point the remote control at the Cable Box/DBS, before pressing other Cable Box/DBS operation buttons.

1

2

Erase Protection

Video cassettes have record tabs to ensure that recordings are not erased accidentally.

1

To prevent accidental erasure, break off the tab with a screwdriver.

2

To record again, cover the hole with cellophane tape.

VCR Maintenance

Remove any light adhesive stick-on notes from the video cassette before putting the cassette in the VCR. Removable labels can jam the VCR.

Periodic maintenance is required to maintain your VCR’s perfor- mance. Your VCR has an automatic head cleaner, but the video heads eventually will require cleaning or replacement. Cleaning or replacement of the video heads should be performed only by an authorized service center.

1

2

Helpful Hints

The remote control and its batteries are supplied.

Do not mix alkaline and manganese batteries.

Do not mix old and new batteries.

Image 5
Contents VRZ255 Model No Serial No Dear Philips Magnavox product ownerFor Customer Use Introduction FeaturesSafety Precautions Table of Contents Before Using Your VCR Disconnect the antenna or cable from your TV Hookups Without a Cable BoxCH3 CH4 Hookups Without a Cable Box cont’dRecording/Viewing Any Channel Hookups With a Cable Box/Direct Broadcast SystemConnections Recording One Channel/Watching Another Cable signal RF coaxial cable TV’sWith this connection Cable Box/DBSPress the FF /OK button. The menu shown below will appear Turning on Your VCRPress the VCR button, then press the Menu button Automatic Channel SetupAdding/Deleting Channels Automatic Channel Setup cont’dInstructions continue on Manual Clock SettingPress the EXIT/STATUS button Setting the Clock cont’dWhen the month and day are correct, press the FF /OK button Press the FF /OK button repeatedly to select Time Time Zone SelectionManual PBS Channel Selection Automatic PBS Channel Selection OFF, PBS CH. and Time Zone will not appear in the menu Daylight-Saving TimePress the EXIT/STATUS button Language SelectionRemote Control Buttons Menu Button Timer ButtonEXIT/STATUS Button Speed ButtonDisplay Panel Front Panel Rear Panel Sound program selected If on Screen Mode is set to on or CounterOperation Find the code for your TV Setting the Remote Control to Operate a TVFind the code for your Cable Box/DBS Setting the Remote Control to Operate a Cable Box/DBSRead and follow the steps below to play a tape PlayingIf playback does not start automatically, press the Play Button. The 3 light will appear on the VCR display panelRecording VCR records in a preset volumePress the VCR button Light will appear on the VCR display panelOne-Touch Recording Channels are set up. Details are on pages 11Starting an OTR Stopping an OTRRecording One Channel/Watching Another Station Setting Up the VCR Plus+ Programming SystemChannels 2Examine the lists on Setting Up the VCR Plus+ Programming System cont’dTimer Recording With the VCR Plus+ Programming System Press the EXIT/STATUS button. Program WAS COM Complete each step within 60 seconds of the previous step Press the VCR button, then press the Timer buttonQuick Programming Tape Speeds Index Programmed timer recordings will appear Checking, Editing, or Clearing Timer RecordingsFollow the steps below to set Timer REC Speed to Auto Timer Recording Speed SettingAudio and video cables are not included Rerecording Tape DuplicationVCR 1 will play your tape. Insert a prerecorded tape in VCR Index Search Receiving a Second Audio Program Multi-Channel Television Sound SystemReceiving a Stereo Broadcast Multi-Channel Television Sound System cont’d Hi-Fi Stereo Tape Playback Video Stabilizer Incredible Picture Forward and Reverse Searching Playback OptionsViewing a Still Picture Viewing a Slow Motion PictureAutomatic Operation Features Cable Box/DBS Output Channel channel 03 or GlossarySpecifications Helpful Hints Helpful Hints cont’d Renewed Glossary Stabilizer Safety precautions Tapes Helpful hints Ac power cord Hookups Slow motion AccessoriesSlp Antenna in jack With a stereo TV ClearingSupplied Accessories