Philips VR400BMG owner manual Hookups Without a Cable Box / Direct Broadcast System

Page 6

6 Hookups Without a Cable Box / Direct Broadcast System

The basic VCR/TV connection – antenna/cable to VCR to TV – is shown below. If you have a Cable Box or a Direct Broadcast System, please see pages eight-nine. If you have a Stereo TV, please see page 10. After you hook up the VCR, go to page 11 to turn on the VCR.

Disconnect the antenna or cable from your TV.

Antenna

Indoor/Outdoor

(300 ohm)

75V
ANT	/
CABLE

75V

ANT /

CABLE

ANTENNA IN

Jack

(on back of TV)

Cable

(75 ohm)

Connect the antenna or cable to the ANT(enna) IN Jack of your VCR.

Antenna

Indoor/Outdoor

(300 ohm)

Back of VCR

ANT

AUDIO
OUT	IN	OUT

Cable

(75 ohm)

ANT

AUDIO

OUT

VIDEO CH3 CH4

VIDEO

CH3 CH4

Image 6

Contents VCR Warranty Verification For Customer UseIntroduction FeaturesSafety Precautions Declaration of ConformityTable of Contents Using the Remote Control Before Using Your VCRPutting Batteries in the Remote Control VCR maintenanceHookups Without a Cable Box / Direct Broadcast System Disconnect the antenna or cable from your TVPlug in the AC power cords of the TV and the VCR CH3 CH4Cable Signal ConnectionsRecording/Viewing Any Channel Cable Box/DBS SignalRecording One Channel/Watching Another CableHookups With a Stereo TV Turning on Your VCR Below will appearAutomatic Channel Setup Press the Menu button until the main menu appearsAutomatic Channel Setup cont’d Adding/Deleting ChannelsSetting the Clock Follow the steps below to set your VCR’s clock. Make sureSetting the Clock cont’d Your selection will flash on the screen in the AM/PM spacePress the Counter RESET/EXIT button to exit Language SelectionOFF mode Press the Display button once Count mode Press the Display button once Clock modeOn-Screen Status Displays Remote Control Buttons Time Search Button Counter RESET/EXIT ButtonEject Button Index Search ButtonVCR Display Panel VCR/TV Button Speed Button Power ButtonRemote Sensor FWD Fast Forward Button Play ButtonVideo OUT Jack AC Power CordRear Panel Video in JackPlaying VHS Quasi Play Back SqpbRead and follow the steps below to play a tape Recording 1Turn on the TV Insert a tapeOne-Touch Recording Starting an OTRStopping an OTR Timer Recording Channels are set up Clock is setTimer Recording cont’d Repeat the procedure in to set the recording’s end timeEnter the recording’s start time Start Time END Time Channel REC Speed SLP Timer Recording cont’d Cancelling a Timer RecordingCorrecting a Timer Recording 42&5Auto Satellite Link Using a Satellite Tuner Set the program to be recorded On the satellite tunerTo return to the channel being recorded, use the TV Press the VCR/TV button on the VCR remote control toRecording One Channel/Watching Another Put the VCR in VCR position. The VCR/TV light will appearRerecording Tape Duplication AntennaRepeat Play Super High Speed Searching LP/SLP Special Effects PlaybackForward and Reverse Searching SP/LP/SLP Viewing a Still PicturePicture Select Press the Play button or the Stop button repeatedly toSelect Picture SELECT. Then, press the F.FWD button Real-Time Counter Memory Press the Play button to watch the tapeIndex Search Press the Index Search buttonTime Search Press the Time Search buttonQuick Find Press the QUICK-FIND buttonTo resume normal tape playback, press the Play button Automatic Playback Features Helpful Hints Helpful Hints cont’d Glossary Cable Box/DBS Output Channel Channel 3 orSpecifications Renewed Index Supplied Accessories