Graco 312787G Installation, Install Color Change Control Module, Location, Mounting

Page 4

Installation

Installation

•To avoid electric shock, turn off equipment power and shut off power at main circuit breaker before installing.

•All electrical wiring must be done by a qualified electrician and comply with all local codes and regulations.

•Do not substitute system components as this may impair intrinsic safety.

To reduce the risk of serious injury, including fluid injection, relieve pressure before installing the kit. Follow the Pressure Relief Procedure in the ProMix 2KS Operation or Service manual.

Install Color Change Control Module

Location

Install the color change control module (101) near the fluid station. The module is approved for use in a haz- ardous location. Also see your system installation man- ual. See FIG. 1.

Mounting

1.See Dimensions, page 24.

2.Ensure that the wall and mounting hardware are strong enough to support the weight of the equip- ment, fluid, hoses, and stress caused during opera- tion.

3.Using the equipment as a template, mark the mounting holes on the wall at a convenient height for the operator and so equipment is easily accessi- ble for maintenance.

4.Drill mounting holes in the wall. Install anchors as needed.

5.Bolt equipment securely.

FSL

101

13

11

SV

FIG. 1: Control Module Installation

FSL

EC

11

SV

TI12828b

4

312787G

Image 4

Contents Important Safety Instructions Color Change Module KitsContents Related ManualsModels Low Pressure KitsHigh Pressure Kits Kit Part No Series DescriptionInstallation Install Color Change Control ModuleLocation MountingTo Install a Second Control Module Connect Module to Fluid Station BoardConnect Air Supply to Control Module Intrinsically Safe can Cables Length in ft mInstallation Install Color Valve Stacks Color Change Board Switch SettingsAccessory Dump Valve Kit Connect Valve Air LinesColor Change Board Switch Settings for ProMix 3KS Systems One Color Change BoardIG Color Change Board Switch Settings PositionsTroubleshooting Cause SolutionProblem Cause Solution Color Change Solenoid ValvesReplace the Color Change Board Fuse Replace a SolenoidFuse Description 123690 Fuse 125 mA, intrinsically safe Color Change Board Diagnostics 256172 Color Change BoardReplace the Color Change Board Pin Nos Description DiagnosisSchematic Diagrams System Pneumatic DiagramWiring Diagram Color Change Module Electrical SchematicSystem Electrical Schematic Non-Hazardous AreaHazardous Area BoardLow Pressure Color Change Kits PartsHigh Pressure Color Change Kits Color Change Kits Parts Color Change Control Modules Ref. No seeControl Module Part Quantities Description QtyTI12826a 277752 2-Color Control Module Description Qty278095 1 Catalyst/1 Flush Control Module 0 Color Dimensions Technical Data Control Module Weight, lb kgGraco Standard Warranty Graco Information