![](/images/new-backgrounds/1217129/2171299x1.webp)
6ENGLISH
ENGLISH 7
3
VITY | + |
OPEN |
|
Power supply:
Power supply:
Using batteries
Operating the Baby unit cordlessly
1Charge the batteries for at least 14 hours
Remove the power adapter from the Baby unit power socket
Use the Baby unit cordlessly for up to 10 hours
2> if the power light flashes red, recharge the batteries
Replacing the battery packs
1Open the Baby unit’s battery compartment cover.
2
Open the Parent unit’s batterycompartment cover .
3 Disconnect the old battery pack from the power plug and remove.
Carefully connect the new battery pack to the power plug and place
4inside the battery compartment.
Close battery compartment cover.
Batteries
Dispose of used batteries in an environmentally friendly manner. Do not mix old and new batteries, or different types of batteries.
Technical specifications
•Battery pack; rechargeable NiMH for Parent and Baby unit (included);
•AC power adapter 230V AC, 50 Hz (two included): - Output voltage 9V DC, 200mA.
•Only use the AC power adapter included
| Problem solving |
|
|
|
|
Problem | Possible cause | Solution |
|
|
|
Power light does not | Parent unit: unit is not turned on. | Turn VOLUME ON/OFF control |
light. |
| downwards. |
|
|
|
| Batteries are low. | Recharge batteries. |
|
|
|
| Baby unit: unit is not turned on. | Push power button. |
|
|
|
| Power adapter is not plugged in or | Plug in power adapter or recharge |
| batteries are low. | batteries. |
|
|
|
High pitched noise. | Units are too close together. | Move parent unit away from baby |
|
| unit. Turn VOLUME ON/OFF |
|
| control on parent unit upwards. |
|
|
|
Batteries | Battery life is at an end. | Connect charging base to mains |
do not charge. |
| power. Replace battery pack. |
|
|
|
No sound. | Volume on parent unit is set too | Turn VOLUME ON/OFF control |
| low. | downwards. |
|
|
|
Power light flashing. | Batteries are low |
|
|
| Recharge the battery packs |
|
|
|
Interference or poor | Mobile or cordless phones too close | Move phones away from the units. |
reception. | to the baby monitor. |
|
|
|
|
Both systems are operating on the | Switch channels. | |
baby monitor. | same frequency. |
|
|
|
|
System check light | Units are out of range or there is | Move units closer together to |
flashing (red) / | interference from another FM | restore the link. Remove the other |
System check alarm. | source. | FM source. |
|
|
|
Operating range: | • up to 250 metres in ideal conditions (walls, floors, etc. can limit this distance.) | ||
Operating temperature: | • |
| |
Digital Pilot tone: | • | Continuous communication link (hidden signal helps reduce interference and ensures a | |
|
| continuous link between both units so you only hear your baby’s sounds). | |
Transmission frequencies: |
| SBC SC466/00: | from 40.695 to 40.675 MHz |
I