Philips SCD609, SCD610 user manual Compliance information, Radio interference

Page 7

Compliance information

The FCC ID number is located on the casing bottom of the parent unit and in the battery compartment of the baby unit.

means that the equipment meets certain radio communications and operational requirements.This device complies with Part 15 of the FCC Rules and RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Radio interference

This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to Part 15 of the FCC Rules and ICES-003 of Industry Canada.These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

--Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.This equipment should be installed and operated with a minimum distance of 7 3/4 inches / 20 centimeters between the radiator and your body. For handheld operation, this equipment has been tested and meets the FCC RF exposure guidelines. For body-worn operation,this product has been tested and meets the FCC RF exposure guideline when used with the belt clip supplied with this product.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Use of other accessories may not ensure compliance with FCC RF exposure guidelines.This equipment also complies with Industry Canada RSS-102 with respect

to Canada’s Health Code 6 for Exposure of Humans to RF Fields.

Do not attempt to repair or modify this equipment

Any repairs or alterations made by the user to the equipment may void the warranty and compliance of the equipment. Changes

not expressly approved by Philips AVENT may void the FCC authorization to operate this equipment. For assistance visit our website www.philips.com/AVENT or call 1-800-54-AVENT (1-800-542-8368).

Do not attempt to repair or modify this equipment

Any repairs or alterations made by the user to the equipment may void the warranty and compliance of the equipment. Changes

not expressly approved by Philips AVENT may void the FCC authorization to operate this equipment. For assistance visit our website www.philips.com/AVENT or call 1-800-54-AVENT (1-800-542-8368).

This Philips AVENT appliance complies with all

handled properly and according to the instructions in this user manual, the appliance is safe to use

8EN

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Register your product and get support at Contents Congratulations on your purchase and welcome IntroductionPage That produce heat Important Safety InstructionsDispose of used batteries according to instructions Clean the parent unit and baby unit with a damp clothReplacement If you need to replace the adapters, use Use the supplied adapter to charge the parent unitThis Philips Avent appliance complies with all Compliance informationRadio interference Reorient or relocate the receiving antennaRecycling Parent unit OverviewBaby unit Charge the parent unit Get startedWall mount the baby unit Set up the baby unit14 EN Parent unit beeps from time to time Use your baby monitorOperating range To see your baby Press on the parent/baby unitVoice activation Adjust brightnessMenu Zoom & PanMenu option Description English French Change the languageSelect ADD CAM Loop all camerasReset Long period of time Guarantee and serviceWarranty Full two-year warrantyIncrease the volume Connect the unit to a powerSwitch on Power supply Supply Battery is empty Baby unit is switched off Switch on the baby unitDecrease the volume Battery light on the parentRecharge the battery Parent unit is running low Battery of the parent unitNight vision LED is still on Baby units light sensor BatteryUnclear in night vision Baby unit may be too Long Feet away from the babySCD610609
Top Page Image Contents