S67-T.qxd 4/5/2007 4:00 PM Page 5
To Assemble Rear Wheels
| 1 | Turn stroller over as shown. |
1 & 2 | 2 | Position Rear Axle Assembly as shown, |
|
| with red brake levers pointing towards |
|
| stroller handle. |
| 3 | Push Rear Axle Assembly onto rear leg |
|
| tubes at the same time. |
Tab locks into hole
4
5
6
4Make sure plastic tabs on rear axle lock into holes on rear legs as shown.
5Slide a Rear Wheel onto the axle then slide a Washer onto the axle.
6Fit straight part of Cotter Pin through hole on axle as shown.
7Line up each of the tabs in the Hub Cap with the slots in the wheel, snap Hub Cap into place.
8Repeat for second side.
To Assemble Front Wheels
Right ▲ | 1 | Place stroller back on handle bars. |
|
|
Left ★
2Locate “▲” and “★” underneath Front Wheel Assembly. Align assembly with
front axle and snap into place as shown.
3 | Repeat for other Front Wheel Assembly. |
| Tug firmly on each wheel assembly to be |
|
sure wheels are securely in place.
NOTE: To remove, push spring loaded button in and pull off wheel.
5