Precor S3.25 manual Preparations, Required Tools, Installation Requirements

Page 5

S3.25 Leg Press Option Assembly Instructions

2 Preparations

CAUTION: To set up this equipment, you will need assistance. Do not attempt assembly by yourself.

You must review and follow the instructions in this guide. If you do not assemble and use the Leg Press Option according to the following guidelines, you could void the Precor limited warranty.

Required Tools

You need to obtain these tools before assembling the unit:

¾-inch socket wrench

¾-inch box-end wrench

⁹⁄₁₆-inch socket wrench

⁹⁄₁₆-inch box-end wrench

Two adjustable pliers or crescent wrenches

Standard set of metric Allen wrenches

Utility knife or scissors

Measuring tape

Installation Requirements

Follow these installation requirements when assembling the unit:

Fill out and mail the limited warranty card. The warranty card is found on the back cover of this guide.

Set up the Leg Press Option on a solid, flat surface. A smooth, flat surface under the unit helps keep it level. A level unit has fewer malfunctions.

Provide ample space around the machine. Open space around the machine allows for easier access.

Insert all bolts in the same direction. For aesthetic purposes, insert all the bolts in the same direction unless specified (in text or illustrations) to do otherwise.

Leave room for adjustments. Tighten fasteners such as bolts, nuts, and screws, so that the unit is stable, but leave room for adjustments. Do not fully tighten fasteners until instructed in the assembly steps to do so.

Assembly Tips

A 6-inch scale is provided at the bottom of every assembly instruction page. Use this scale to identify the correct size bolts and spacers. The head of a bolt is not used in measuring the length of a bolt.

To find out the length of a particular bolt, measure its shank (the long, narrow part beneath the head). Refer to the following diagram.

Read all caution notes on each page before completing that step.

Bolt head

Bolt threads

To determine the

length of a bolt,

 

measure its shank.

Shank

Some pieces have extra holes that you will not use. Use only those holes indicated in the instructions and illustrations.

While you may be able to assemble the Leg Press Option by using the illustrations only, refer to the text for important safety cautions and notes.

Preparations

page 5

Image 5
Contents S3.25 Obtaining Service Important Safety InstructionsTable of Contents Unpacking the Equipment 1Before You BeginBefore You Begin Required Tools Installation RequirementsPreparations Professional installers are highly recommended AssemblyInstructionsAssembly Instructions Remove the Shroud Attach the Cross Brace to the S3.25 Assemble the Frame Footrest Assemble the Seat Pads Route the Cable Assemble the Cable and Pulleys New Surgical Tube Replace the Shroud Stretch the Cable AdjustmentsRotate the Cam Washer Adjust the Rubber Bumper on the Leg Press Option Thank You and Welcome to Precor Purchased From Date Product Serial Purchase NumberPlease indicate the type of product purchased Gender Marital status Age Annual household incomePrecor Residential Equipment Limited Warranty S3.25 Leg Press Option Specifications
Related manuals
Manual 22 pages 61.67 Kb Manual 20 pages 29.11 Kb