Route the Cable | Precor S3.25 specification

S3.25 Leg Press Option Assembly Instructions

5. Route the Cable

As you route the Cable through the pulleys on the Leg Press Option, wrench tighten the fasteners on each pulley as you go. Make sure that the Cable slides freely along the pulley (and beneath the cable retainer). Make sure that you are using the correct Cable before you tighten the fasteners.

A.Attach the barrel end of Cable 40538-103 to the Seat Frame using

one 4-inch bolt one washer one locknut

Wrench tighten so that the barrel end of the Cable rotates freely.

B.Loosen all the fasteners that attach the pulleys to the Seat Frame.

C.Push the Pivot Arm forward so that the pulleys are easily accessible.

D.Route the Cable around the pulley inside the Pivot Arm Cover that is on the same side as the barrel end of the Cable (see illustration). The Cable should slide along the pulley beneath the cable retainer. Wrench tighten this pulley’s fasteners.

E.You may need to slide the bolt out of the Pivot Arm Cover to wrap the Cable around the pulley.

F.Continue to route the Cable around the pulleys as shown in the illustration. Make sure that the Cable slides freely along the pulleys (and beneath the cable retainers) before you wrench tighten their fasteners.

G.Wrap the Cable around the 4½-inch pulley (and beneath its cable retainer) that is attached to the Cross Brace. Wrench tighten.

Pivot Arm